Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver , an adjustable

wrench , and a rubber mallet .

See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not found in the parts bag, check to see if it has been pre-assembled.

M8 Nylon	M6 Washer	M8 Split	M8.5 Washer	M10 Split	Wave Washer	M10 Washer
Locknut (46)–4	(58)–2	Washer (94)–10	(53)–2	Washer (144)–2	(150)–2	(99)–2

M4 x 16mm

M4 x 16mm Round

M4 x 14mm Round

M4 x 12mm

M6 x 16mm Tapered

Screw (66)–6

Head Screw (45)–1

Head Screw (93)–2

Screw (84)–6

Button Screw (107)–8

M6 x 18mm Button	M8 x 25mm Patch	M8 x 38mm Button	M8 x 43mm Button
Screw (67)–4	Screw (22)–2	Screw (70)–2	Bolt (50)–4

M8 x 45mm Button	M8 x 54mm Button	M10 x 35mm Carriage
Screw (102)–4	Screw (33)–4	Bolt (20)–2

Union Bolt Set (27)–2

M4 x 52mm Screw (98)–2