Using the time alignment, Adjusting the time alignment

Digital Signal Processor

3Touch c or d to adjust the speaker out- put level.

Each time you touch cor d increases or de- creases the speaker output level. +10 to –10 is displayed as the level is increased or de- creased.

# The test tone rotates to the next speaker after about two seconds from the last operation.

4Touch STOP to stop the test tone out- put.

Notes

!If needed, select speakers and adjust their ‘ab- solute’ output levels. (Refer to Adjusting the speaker output levels on page 89.)

!To adjust the speaker output levels in this mode is the same as making the speaker out-

put levels at SPEAKER LEVEL. Both provide the same results.

Using the time alignment

Only when the multi-channel processor (e.g., DEQ-P8000) is connected to this unit, you can operate this function.

The time alignment lets you adjust the dis- tance between each speaker and the listening position.

1Touch TIME ALIGNMENT on the DSP function menu.

2Touch any of the following touch panel keys to select the time alignment.

!INITIAL – Initial time alignment (factory set- ting)

!AUTO TA – Time alignment created by auto TA and EQ. (Refer to Auto TA and EQ (auto- time alignment and auto-equalizing) on page 94.)

Section

!CUSTOM – Adjusted time alignment that you can create for yourself

!OFF – Turn the time alignment off

!ADJUST – Adjust the time alignment as de- sired

#You cannot select AUTO TA if auto TA and EQ has not been carried out.

#You cannot select ADJUST when neither FRONT-L nor FRONT-R is selected in POSITION.

	You can adjust the distance between each	Digital
	speaker and the selected position.	Digital
	! An adjusted time alignment is memorized	Signal
	! An adjusted time alignment is memorized
	in CUSTOM.
	1 Touch TIME ALIGNMENT on the DSP	Processor
	function menu and then touch ADJUST.	Processor
	function menu and then touch ADJUST.
	# You cannot select ADJUST when neither
	FRONT-L nor FRONT-R is selected in POSITION.
	2 Touch c or d to select the speaker to
	be adjusted.
	Each time you touch cor d selects the speak-
	er in the following order:
	FRONT-L (front speaker left)—CENTER (center
	speaker)—FRONT-R (front speaker right)—
	REAR-R (rear speaker right)—REAR-L (rear
	speaker left)—SUB WOOFER (subwoofer)
	# You cannot select speakers whose size is set
	at OFF. (Refer to Setting the speaker setting on
	page 88.)
	3 Touch c or d to adjust the distance be-
	tween the selected speaker and the listen-
	ing position.
	Each time you touch cor d increases or de-
	creases the distance. 0.0 to 200.0 [inchs] is
	displayed as the distance is increased or de-
	creased.
	4 Touch ESC to return to the playback dis-
	play.

En 91