Pioneer AVH-P6000DVD 22Initial Setup, Switching the sound muting/attenuation, 104 En

Section

22Initial Setup

#When a subwoofer is connected to the rear output, select SUB. W (subwoofer).

#When the rear output setting is SUB. W, you cannot change the subwoofer controller.

3Touch c or d on the PREOUT setting to switch the subwoofer output or non fading output.

Touch c to select subwoofer output and SUB.W appears in the display. Touch d to se- lect non fading output and FULL appears in the display.

Notes

!Even if you change this setting, there is no output unless you turn the nonfading output (refer to Using nonfading output on page 82) or subwoofer output (refer to Using subwoofer output on page 82) in the audio menu on.

!If you change the subwoofer controller, sub-

woofer output and nonfading output in the audio menu return to the factory settings.

Switching the sound muting/attenuation

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!The sound is turned off, MUTE is displayed and no audio adjustments are possible.

!The sound is attenuated, ATT is displayed and no audio adjustments, except volume control, are possible.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

%Touch TEL/GUIDE on the initial menu to select any of the muting, attenuation or off.

Touch TEL/GUIDE until the desired setting ap- pears in the display.

!MUTE – Muting

!ATT -20dB – Attenuation (ATT -20dB has a stronger effect than ATT -10dB)

!ATT -10dB – Attenuation

!OFF – Turn the sound muting/attenuation off

Notes

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjustment is possible.

!Operation returns to normal when the phone connection or the voice guidance is ended.

Mixing AVG-VDP1 beep and audio sound

When connecting the AVG-VDP1 to this unit, a beep sound is occasionally outputted from the AVG-VDP1. To ensure the quality audio sound from this unit, set this function to GUIDE to properly mix the beep sound and the audio sound.

!You can operate this function only when a Pioneer Vehicle Dynamics Processor (AVG- VDP1) is connected to this unit.

!When the multi-channel processor (e.g., DEQ-P8000) is connected to this unit, you cannot use this function.

!We recommend that you select GUIDE to ensure quality sound.

104 En