Pioneer AVH-P6000DVD 19Digital Signal Processor, Refer to Using the position selector on page

Section

19Digital Signal Processor

#Press SOURCE to turn the source on if this unit is turned off.

4Select the position for the seat on which the microphone is placed.

Refer to Using the position selector on page

# If no position is selected before you start auto TA and EQ, FRONT-L is selected automatically.

5Press SOURCE and hold until the unit turns off.

6Touch and hold EQ to enter the auto TA and EQ measurement mode.

7Plug the microphone into the micro- phone input jack on the multi-channel pro- cessor.

#To cancel auto TA and EQ part way through, touch BACK or ESC.

10When auto TA and EQ is completed, Complete is displayed.

When correct measurement of car interior acoustic characteristics is not possible, an error message is displayed. (Refer to Under- standing auto TA and EQ error messages on page 115.)

11Touch ESC to cancel the auto TA and EQ mode.

12Store the microphone carefully in the glove compartment.

Store the microphone carefully in the glove compartment or any other safe place. If the microphone is subjected to direct sunlight for an extended period, high temperatures may

cause distortion, color change or mal- function.

AUTO TA&EQ microphone

For details concerning operation, refer to the multi-channel processor’s operation manual.

8Touch START to start the auto TA and

EQ.

9Get out of the car and close the door within 10 seconds when the 10-second count-down starts.

The measurement tone (noise) is outputted from the speakers, and auto TA and EQ be- gins.

# When all speakers are connected, auto TA and EQ is completed in about nine minutes.

# To stop auto TA and EQ, touch STOP.

96 En