Pioneer AVH-P6000DVD operation manual Digital Signal Processor, Introduction of DSP adjustments

Digital Signal Processor

Introduction of DSP adjustments

1

You can use this unit to control multi-channel processor (e.g. DEQ-P8000), which is sold sepa- rately.

!Some functions may differ depending on the multi-channel processor connected to this unit.

By carrying out the following settings/adjust- ments in the order shown, you can create a fi- nely-tuned sound field effortlessly.

1Setting the speaker setting

2Using the position selector

3Auto TA and EQ (auto-time alignment and auto- equalizing)

4Adjusting the time alignment

5Adjusting the speaker output levels using a test tone

6Selecting a cross-over frequency

7Adjusting the speaker output levels

8Adjusting 3-band parametric equalizer

1DSP display

Shows the DSP function names.

1Touch AUDIO MENU to display MENU. MENU appears on the display.

2Touch DSP to display the DSP function names.

The DSP function names are displayed and operable ones are highlighted.

Section

19

# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# When playing discs recorded with more than
96 kHz sampling frequency, you cannot use audio
functions. Also, equalizer curve setting,
POSITION, AUTO EQ and AUTO TA will be can-
celled.
# When playing discs recorded with more than
96 kHz sampling frequency, audio is outputted	Digital
from front speakers only.
# When selecting FM as the source, you cannot
switch to SLA.
# When playing other than the DVD disc, you	Signal
cannot switch to D.R.C.
# When neither FRONT-L nor FRONT-R is se-
lected in POSITION, you cannot switch to	Processor
cannot switch to DOLBY PRO LOGIC II.
TIME ALIGNMENT.
# When both the center speaker and the rear
speaker are set to OFF in the speaker setting, you
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Note
If you do not operate the DSP function within
about 30 seconds, the display is automatically re-
turned to the source display.

Using the position selector

One way to assure a more natural sound is to accurately position the stereo image, putting you right in the center of the sound field. The position selector function lets you automati- cally adjust the speaker output levels and in- serts a delay time to match the number and position of occupied seats.

En 85