ProForm PFB48030 user manual Attach the Left Fly Arm 44 in the same, Manner

28. Press two 50mm Square Inner Caps (22) into the	28
Butterfly Frame (42).			110
Attach the Butterfly Frame (42) to the Rear Top			99
Frame (39) with two M10 x 78mm Bolts (110), two			99
M10 Washers (99), and two M10 Nylon Locknuts			39
(97). Do not tighten the Locknuts yet.
Attach the Butterfly Frame (42) to the Center				37
			97
Upright (37) with two M10 x 68mm Bolts (113),
two M10 Washers (99), and two M10 Nylon		97
Locknuts (97). Do not tighten the Locknuts yet.
Tighten all of the M10 Nylon Locknuts (97)	22
used in steps 11–28. Tighten the 1/4” x 14mm			42
Screws (119) used in step 22 and the 1/4” x
9.5mm Allen Head Set Screws (120) used in
step 23.
	113	99	22
29. Lubricate both axles on the Butterfly Frame (42)	29
with grease.
Press two 50mm Square Inner Caps (22) into the	Lubricate Axle
ends of the Right Fly Arm (43). Insert a Fly Arm	92
Bushing (92) into the Arm. Wet the end of the
			42
Arm with soapy water and slide a Fly Foam Pad
(95) onto it.	43		Bracket
Have another person slide the Right Fly Arm (43)	93		22	44
onto the right axle on the Butterfly Frame (42).
Note: Be careful not to confuse the Left Fly		94
Arm (44) with the Right Fly Arm. Make sure
that the upper end of the Arm is behind the
indicated bracket on the Butterfly Frame.	22
Tap two 25mm Retainer Rings (93) onto the axle of	95
the Butterfly Frame (42) with the included retainer			Axle
tool. Make sure that the teeth on the Retainer
			42
Rings bend toward the tool, as shown in the
inset drawing. Tap the 25mm Round Outer Cap			93
(94) onto the right axle on the Butterfly Frame.
Attach the Left Fly Arm (44) in the same			Retainer
manner.
			Tool
30. During cable assembly, refer to the CABLE	30
DIAGRAMS on page 22 for cable identification
and to verify cable routing.
Locate the Butterfly Cable (83). Attach the			129
Cable to the Left Fly Arm (44) with an M8 x
16mm Shoulder Bolt (129) and an M8 Nylon			83
Locknut (96).
			96
		44
	14