ProForm PFB48030 user manual Troubleshooting, Tightening the Cables

Page 23

TROUBLESHOOTING

Make sure all parts are properly tightened each time the weight bench is used. Replace any worn parts immediate- ly. The weight bench can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight bench, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the cables in several ways:

See drawing 1. To tighten the cables, remove the M10 Nylon Locknut (97) and the M10 x 45mm Bolt

(112)from the lower 90mm Pulley (90), Cable Trap (125), and the Pulley Plates (72). Reattach the Pulley and the Cable Trap between a set of holes closer to the center of the Pulley Plates with the Bolt and Locknut. Make sure the Cable Trap is oriented to hold the Low Cable (82) in the groove of the Pulley.

See drawing 2. Additional slack can be removed from the cables by tightening a cable into the M6 Nylon Locknut (124) inside a Cable End Clip (85). To do this, pull the Clip Cover (84) back and use pliers to tighten the Locknut. Replace the Cover.

1

72 72

97

112

90 125

82

2

124

Cable

84 85

Do not overtighten the cables. If a cable slips off the pulleys repeatedly, it may have become twisted. Remove the cable and re-install it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

23

Image 23
Contents Customer HOT Line QUESTIONS?Model No. PFB48030 Serial No Table of Contents Important Precautions Left Side Before YOU BeginRight Side Locknuts yet AssemblyMake Things Easier for Yourself Lubricate Tighten the six M10 Nylon Locknuts 97 used in steps 1 Flat Head Screw 27 is under a notch in the Backrest BracketInto the Pad Tube. Repeat with the other Do not tighten the Locknuts yet Do not tighten the Locknuts yet Not tighten the Screw yet Locknuts 97. Do not tighten the Locknuts yetNylon Locknut 97. Do not tighten the Locknut Yet Holes in the Rear Upright. Do not tighten Locknuts yet Manner Attach the Left Fly Arm 44 in the samePage Locknut the Cable must be able to pivot Locate the Lat Cable 81. Route the Cable upCable Trap is turned to hold the Cable Groove of the Pulley 127 Locknut the Cable must be able to pivot easily Attaching the Curl Post AdjustmentsAdjusting the Backrest Attaching the Accessories Using the Olympic Weight AdapterAdding Weights to the LEG Lever Moving the Safety Spotters Adding Weights to the Barbell or the Weight CarriageUsing the Locking BAR Low Cable Cable DiagramsButterfly Cable Lat CableTightening the Cables TroubleshootingExercise Guidelines Staying Motivated Cooling DownThursday Aerobic Exercise Date Exercise Weight Sets RepsDate Aerobic ExerciseMonday R1103A Part Identification CHART-Model No. PFB48030Page Page Key Qty Description Part LIST-Model No. PFB48030Exploded DRAWING-Model No. PFB48030 Exploded DRAWING-Model No Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty