ProForm PFANSY9825.1 user manual Repeat this step with the Leg Lever 4 and the Short Pad Tube

Page 22

61.Attach the Lock Plate (21) to the Right Seat Frame (3) with an M8 x 68mm Shoulder Bolt (41), an M8 Washer (98), and an M8 Nylon Locknut

(91).Do not overtighten the Locknut; the Lock Plate must be able to pivot easily.

Attach the Leg Pin (24) to the Right Seat Frame

(3)with an M4 x 16mm Self-tapping Screw (89). Insert the Leg Pin through the Leg Lever (4) and the Lock Plate (21).

62.Insert the Long Pad Tube (16) into the Right Seat Frame (3). Slide two Small Foam Pads (18) onto the Pad Tube. Press two Foam Caps (17) into the Pad Tube.

Repeat this step with the Leg Lever (4) and the Short Pad Tube (35).

	61
	91	3
	98	3
	98
	89
	24	21
	4	21
	4
		41
	62
	17
	18
		3
	16
		18
		4
		17
	35

63.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.

Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 28.

22

Image 22

Contents QUESTIONS? Model No. PFANSY9825.1 Serial NoTable of Contents Important Precautions Right Side Before YOU BeginLeft Side Assembly Frame Assembly Page Page Weight Tube sits in the groove in the top Weight Repeat this step with the other Weight GuideTighten the M8 Nylon Locknuts 91 used in steps Arm AssemblyLocknuts yet Repeat this step with the Right Butterfly ArmRepeat this step with the other Press Arm Cable Assembly Finger Guards are oriented as shown Guards are oriented as shownTrap and Finger Guards are oriented as Shown Cable Trap and Finger Guards are oriented asMake sure the Finger Guards are oriented as Shown Page 106 Flat Edge 108 103 110 102 110 Identify the Ab Cable 107. Route the small ball Over the rod in the Seat Frame107 Seat Assembly Is inserted through both Finger Guards and is Over the CablePage Repeat this step with the Leg Lever 4 and the Short Pad Tube Attaching the Accessories to a Pulley Station AdjustmentsChanging the Weight Setting Using the Lock PlateAdjusting the Backrest Locking the Weight StackWeight Resistance Chart LbsShort Cable Cable DiagramsButterfly Cable Ab CableWeight Cable Press CableMaintenance Tightening the CablesExercise Guidelines Cooling Down Muscle ChartStaying Motivated Aerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DateSave this Part Identification Chart for Future Reference Part Identification CHART-Model No. PFANSY9825.1 Page Part LIST-Model No. PFANSY9825.1 Qty DescriptionSave this Part LIST/EXPLODED Drawing for Future Reference Exploded Drawing A-Model No. PFANSY9825.1 Exploded Drawing B-Model No. PFANSY9825.1 Ordering Replacement Parts