JVC RX-D301S, RX-D302B manual For Canada/pour le Canada, For U.S.A

Page 2

Warnings, Cautions, and Others

Mises en garde, précautions et indications diverses

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,

 

DO NOT REMOVE COVER (OR BACK).

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

Caution–– STANDBY/ON button!

Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled.

Attention—Touche STANDBY/ON!

Déconnectez la fiche d’alimentation secteur pour couper

l’alimentation complètement. La touche STANDBY/ON, dans n’importe quelle position, ne déconnecte pas le système du secteur. L’alimentation ne peut pas être télécommandé.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND

CAUTION

Changes or modifications not approved by JVC could void the user’s authority to operate the equipment.

For U.S.A

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

For U.S.A

Declaration of Conformity:

Trade Name:

JVC

Model Number:

RX-D301S/RX-D302B

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including interference that may cause undesired operation.

Responsible Party: JVC Americas Corp.

Address:1700 Valley Road, Wayne

New Jersey 07470

Telephone Number: 973-317-5000

For USB wireless transmitter

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including interference that may Cause undesired operation.

CAUTION: To maintain compliance with FCC’s RF exposure guidelines, this equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Use on the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations.

For Canada/pour le Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

For Canada/pour le Canada

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.

Image 2
Contents RX-D301S / RX-D302B For Customer UseFor U.S.A For Canada/pour le CanadaFor Canada/pour le Canada Table of Contents Parts identification Remote controlWhen operating a DVD player, set the mode selector u to DVD Rear panel Front panelDisplay window Checking the supplied accessories Before InstallationPutting batteries in the remote control Getting startedAntenna Connecting the FM and AM antennasFM antenna connection Connecting the speakers Connecting the speakersSpeaker Layout Diagram Connecting the powered subwooferOnly for DVD recorder To S-video input Connecting video componentsTurn off all components before making connections If your video components have AV Compu Link terminalÈ Ô About DVD MultiVCR Å Blue Red Connecting a TVGreen Digital input terminals About video signal conversionDigital connection Digital output terminalUSB Connection For USB TerminalConnecting the power cord Selecting the analog or digital input mode Turn on the powerTo turn off the power into standby Basic operationsListening with headphones Adjust the volumeSelecting the digital decode mode To restore the sound, press Muting againSignal and speaker indicators on the display Turning off the power with the Sleep TimerBasic adjustment of auto memory Changing the display brightnessPress SET Basic settingsPress Setting Before you start, rememberRoom size and the speaker distance/output level Basic setting itemsSpeakers channels number and the size Setting the surround back speakers-S Back OUT Setting the speakersSetting subwoofer information-SUBWOOFER Turn Multi JOG to select the appropriate settingFrom the remote control Activating the EX/ES/PLIIx setting- EX/ES/PLIIxSetting the speaker distance AutoSelecting the main or sub channel Setting bass soundUsing the Midnight mode VCR S/C Memorizing the volume level for each source-ONE Touch OPEDVD S/C OnetouchonOperating procedure Sound adjustmentsBasic adjustment items Adjusting the speaker output levels Press Test to check the speakers’ output balanceAdjusting the virtual room size for DSP modes Adjusting the bass soundsAttenuating the input signal-INPUT ATT Adjusting the liveness effect for DSP modesAdjusting the center tone-CENTER Tone To store the preset stations Tuning in to stations manuallyUsing preset tuning Tuner operationsSelecting the FM reception mode To tune in a preset stationIntroducing the Surround modes Creating realistic sound fieldsReproducing theater ambience Dolby DigitalDTS 3D Headphone modeAbout other digital signals Digital Acoustic Processor DAP modes All Channel Stereo mode ALL CH StereoIntroducing the DSP modes About the DSP modes Using the Surround/DSP modesDTSDolby Digital Incoming Signal Type Virtual Surround BackSelecting the Surround/DSP modes When you select Auto SurroundTurn Multi JOG to select the Surround/DSP mode you want Select and play any source other than DVD MultiConnections 2 Video cable connection AV Compu Link remote control systemConnections 1 AV Compu Link connection CaseAutomatic power on/off Connecting procedureAutomatic selection of TV’s input mode One-touch video playChannel + Operating other JVC productsVCR REWRelease DVR/DVD Changing the remote control code for DVD recorderDVD recorder or DVD player TOP MENU/MENURelease TV Changing the transmittable signals for operating a TVOperating other manufacturers’ products Try to operate your TV by pressing TVTry to operate your VCR by pressing VCR Changing the transmittable signals for operating a VCRRelease VCR Manufacturers’ codes for VCRManufacturers’ codes for DBS tuner Release DBS/CATVManufacturers’ codes for Catv converter Try to operate your DVD player by pressing DVR/DVDProblem Possible Cause Solution TroubleshootingPower Remote control TunerFM tuner IHF SpecificationsAmplifier AM tunerPage Page Audio Video Control Receiver RX-D302B Mises en garde, précautions et indications diverses English Parts identification ID Learning 1DVR/DVD Getting started AM antenna connection Connecting the speakers Connecting video components È Ô Red DBS tuner Component video cable not suppliedWhite Video cable not suppliedAbout video signal conversion USB wireless Transmitter supplied Connecting the power cord Basic operations Auto Surr Digital Changing the display brightness Basic settings Basic setting items Setting the speakers Activating the EX/ES/PLIIx setting- EX/ES/PLIIx Dual Mono DBS Video Sound adjustments Adjusting the speaker output levels Adjusting the bass sounds Dimension Tuner operations Selecting the FM reception mode Creating realistic sound fields DTS Introducing the DSP modes Digital When activating NEO6 MUSIC, you can adjust Center RX-D302B Equipment To video input Connecting procedure Operating other JVC products DVD recorder or DVD player Operating other manufacturers’ products English Release DBS/CATV There are any problems you cannot solve, contact your JVC’s Specifications RX-D302B