JVC RX-D302B, RX-D301S manual Operating other JVC products

English

7 VCR

Operating other

JVC products

You can use the supplied remote control to operate not only this receiver but also other JVC products.

•Refer also to the manuals supplied with the other products.

–Some JVC VCRs can accept two types of the control signals—remote codes “A” and “B.” This remote control can operate a VCR whose remote control code is set to “A.”

–Some JVC DVD recorders can accept four types of the control signals. This remote control can operate a DVD recorder whose remote control code is set to the initial code. For details, refer to the manual supplied with the DVD recorder.

•To operate other products, aim the remote control directly at the remote sensor on the target product.

1 2 3

4 5 6

7 8 9

10 0 10

7TV

1 2 3

4 5 6

7 8 9

10 0 10

You can always perform the following operations:

TV : Turn on or off the TV.

TV VOL +/–:Adjust the volume on the TV.

TV/VIDEO:Change the input mode (either video input or TV tuner) on the TV.

After pressing TV, you can perform the following operations on the TV.

CHANNEL +/–:Change the channel numbers.

1 – 9, 0, 100+ (+10): Select the channel numbers.

RETURN (10): Switch between the previous channel and the current channel.

You can always perform the following operation:

VCR : Turn on or off the VCR.

After pressing VCR, you can perform the following operations on the VCR.

CHANNEL +/–:	Change the channel numbers on the
	VCR.
1 – 9, 0:	Select the channel numbers on the
	VCR.
3:	Start playback.
7:	Stop playback.
8:	Pause playback. To release it, press 3.
FF:	Fast-wind a tape.
REW:	Rewind a tape.
REC PAUSE:	Enter recording pause. To start
	recording, press this button then 3.

36