JVC RX-D301S Connecting the speakers, Speaker Layout Diagram, Connecting the powered subwoofer

Connecting the speakers

Do not connect the AC power plug to the wall outlet until all connections are completed.

Speaker Layout Diagram

		SW
L	C	R
LS		RS
SBL	(*SB)	SBR

Right surround back speaker (SBR)

*Left surround back speaker (SBL)

Right surround

speaker (RS)

Center
speaker (C)	SUBWOOFER
	OUT
CAUTION:SPEAKER
IMPEDANCE 6 -16

RIGHT	LEFT	RIGHT	LEFT		RIGHT	LEFT
SURROUND BACK		SURROUND		CENTER	FRONT	Powered
SPEAKERS		SPEAKERS		SPEAKER	SPEAKERS

subwoofer

(SW)

Left surround	Right front	Left front
speaker (LS)	speaker	speaker
	(R)	(L)

CAUTIONS:

•Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals (6 Ω – 16 Ω).

•DO NOT connect more than one speaker to one speaker terminal.

Connecting the speakers

Turn off all components before making connections.

Connecting the center speaker and the front speakers

1 2 3 4

1Twist and remove the insulation at the end of each speaker cord.

2Turn the knob counterclockwise.

3Insert the speaker cord.

•For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

4Turn the knob clockwise.

Connecting the surround speakers and the surround back speakers

1	2	1	3
		2

+	+
–	–

1Twist and remove the insulation at the end of each speaker cord.

2Open the terminal (1), then insert the speaker cord (2).

•For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

3Close the terminal.

*When using a single speaker for the surround back speaker

You can enjoy the surround sound by one surround back speaker. When using one surround back speaker,

–set “SB OUT” to “<1SPK>” (see page 19) and

–connect the surround back speaker to the left surround back speaker terminal. (No sound comes from the speaker if you connect it to the right surround back speaker terminal.)

Connecting the powered subwoofer

By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in digital software.

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cord with RCA pin plugs (not supplied).

• Refer also to the manual supplied with your subwoofer.

After connecting all the speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible surround effect. For details, see pages 17 to 21.

NOTE

You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you.

6