JVC RX-D302B, RX-D301S manual Mises en garde, précautions et indications diverses

Page 49

Warnings, Cautions, and Others

Mises en garde, précautions et indications diverses

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,

 

DO NOT REMOVE COVER (OR BACK).

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

Caution–– STANDBY/ON button!

Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled.

Attention—Touche STANDBY/ON!

Déconnectez la fiche d’alimentation secteur pour couper

l’alimentation complètement. La touche STANDBY/ON, dans n’importe quelle position, ne déconnecte pas le système du secteur. L’alimentation ne peut pas être télécommandé.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND

CAUTION

Changes or modifications not approved by JVC could void the user’s authority to operate the equipment.

For U.S.A

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

For U.S.A

Declaration of Conformity:

Trade Name:

JVC

Model Number:

RX-D302B

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received,

including interference that may cause undesired operation. Responsible Party: JVC Americas Corp.

Address:1700 Valley Road, Wayne

New Jersey 07470

Telephone Number: 973-317-5000

For USB wireless transmitter

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received,

including interference that may Cause undesired operation. CAUTION: To maintain compliance with FCC’s RF exposure guidelines, this equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Use on the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations.

For Canada/pour le Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

For Canada/pour le Canada

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.

Image 49
Contents For Customer Use RX-D301S / RX-D302BFor Canada/pour le Canada For Canada/pour le CanadaFor U.S.A Table of Contents When operating a DVD player, set the mode selector u to DVD Remote controlParts identification Display window Front panelRear panel Putting batteries in the remote control Before InstallationChecking the supplied accessories Getting startedFM antenna connection Connecting the FM and AM antennasAntenna Speaker Layout Diagram Connecting the speakersConnecting the speakers Connecting the powered subwooferTurn off all components before making connections Connecting video componentsOnly for DVD recorder To S-video input If your video components have AV Compu Link terminalAbout DVD Multi È ÔVCR Å Green Connecting a TVBlue Red Digital connection About video signal conversionDigital input terminals Digital output terminalFor USB Terminal USB ConnectionConnecting the power cord To turn off the power into standby Turn on the powerSelecting the analog or digital input mode Basic operationsSelecting the digital decode mode Adjust the volumeListening with headphones To restore the sound, press Muting againBasic adjustment of auto memory Turning off the power with the Sleep TimerSignal and speaker indicators on the display Changing the display brightnessPress Setting Basic settingsPress SET Before you start, rememberSpeakers channels number and the size Basic setting itemsRoom size and the speaker distance/output level Setting subwoofer information-SUBWOOFER Setting the speakersSetting the surround back speakers-S Back OUT Turn Multi JOG to select the appropriate settingSetting the speaker distance Activating the EX/ES/PLIIx setting- EX/ES/PLIIxFrom the remote control AutoUsing the Midnight mode Setting bass soundSelecting the main or sub channel DVD S/C Memorizing the volume level for each source-ONE Touch OPEVCR S/C OnetouchonBasic adjustment items Sound adjustmentsOperating procedure Press Test to check the speakers’ output balance Adjusting the speaker output levelsAttenuating the input signal-INPUT ATT Adjusting the bass soundsAdjusting the virtual room size for DSP modes Adjusting the liveness effect for DSP modesAdjusting the center tone-CENTER Tone Using preset tuning Tuning in to stations manuallyTo store the preset stations Tuner operationsTo tune in a preset station Selecting the FM reception modeReproducing theater ambience Creating realistic sound fieldsIntroducing the Surround modes Dolby DigitalAbout other digital signals 3D Headphone modeDTS Introducing the DSP modes All Channel Stereo mode ALL CH StereoDigital Acoustic Processor DAP modes DTSDolby Digital Incoming Signal Type Using the Surround/DSP modesAbout the DSP modes Virtual Surround BackTurn Multi JOG to select the Surround/DSP mode you want When you select Auto SurroundSelecting the Surround/DSP modes Select and play any source other than DVD MultiConnections 1 AV Compu Link connection AV Compu Link remote control systemConnections 2 Video cable connection CaseAutomatic selection of TV’s input mode Connecting procedureAutomatic power on/off One-touch video playVCR Operating other JVC productsChannel + REWDVD recorder or DVD player Changing the remote control code for DVD recorderRelease DVR/DVD TOP MENU/MENUOperating other manufacturers’ products Changing the transmittable signals for operating a TVRelease TV Try to operate your TV by pressing TVRelease VCR Changing the transmittable signals for operating a VCRTry to operate your VCR by pressing VCR Manufacturers’ codes for VCRManufacturers’ codes for Catv converter Release DBS/CATVManufacturers’ codes for DBS tuner Try to operate your DVD player by pressing DVR/DVDPower TroubleshootingProblem Possible Cause Solution Remote control TunerAmplifier SpecificationsFM tuner IHF AM tunerPage Page Audio Video Control Receiver RX-D302B Mises en garde, précautions et indications diverses English Parts identification ID Learning 1DVR/DVD Getting started AM antenna connection Connecting the speakers Connecting video components È Ô Red White Component video cable not suppliedDBS tuner Video cable not suppliedAbout video signal conversion USB wireless Transmitter supplied Connecting the power cord Basic operations Auto Surr Digital Changing the display brightness Basic settings Basic setting items Setting the speakers Activating the EX/ES/PLIIx setting- EX/ES/PLIIx Dual Mono DBS Video Sound adjustments Adjusting the speaker output levels Adjusting the bass sounds Dimension Tuner operations Selecting the FM reception mode Creating realistic sound fields DTS Introducing the DSP modes Digital When activating NEO6 MUSIC, you can adjust Center RX-D302B Equipment To video input Connecting procedure Operating other JVC products DVD recorder or DVD player Operating other manufacturers’ products English Release DBS/CATV There are any problems you cannot solve, contact your JVC’s Specifications RX-D302B