Weider WEBE4496.0 Swivel Arm. Make sure the Cable is routed, Under the bar in the Swivel Arm

38. Wrap the Cable (131) over a Small Pulley (59).	38
Attach the Small Pulley and a Cable Trap (76) to
the inside of the Rear Frame (31) with an M10 x
45mm Bolt (104) and an M10 Nylon Locknut (94).				59	76
			131		104
			94
					31
39. Remove the M4 x 12mm Self-tapping Screw	39
(123) and the Swivel Arm (48) from the Left Front
Frame (32). Route the Cable (131) through the		102	64
slot in the Left Front Frame and through the
Swivel Arm. Make sure the Cable is routed	The Cable		65
under the bar in the Swivel Arm.
	must pass
Attach the Swivel Arm (48) to the Left Front	on this side	123
	of the Bolt.
Frame (32) with the M4 x 12mm Self-tapping
	48
Screw (123).
Position the Bottom Plate (65) and the Top Plate	Bar		32
	131
(64) around the Cable (131) as shown. Attach the
Bottom and Top Plates to the Left Front Frame
(32) with two M4 x 16mm Self-tapping Screws
(102).
40. Attach a Small Pulley (59), two 16mm x 6mm	40
Spacers (91), an Outer Pulley Cover (63), and an
Inner Pulley Cover (82) to the Swivel Arm (48)
with an M10 x 60mm Bolt (117), two M10
Washers (96), and an M10 Nylon Locknut (94).
Make sure the Spacers are inside the Swivel	94			96
Arm.
	96	48
	63		59
	91		91 82	117
	131
	20