Weider WEBE4496.0 user manual Repeat this step for the other Arm Pad not shown

Page 23

47.Attach the Backrest (73) to the Center Upright (29) with two M6 x 63mm Screws (106) and two M6 Washers (98).

Attach the Headrest (72) to the Center Upright (29) in the same manner.

48.Attach an Arm Pad (74) to the VKR Arm (52) with two M6 x 57mm Screws (113) and two M6 Washers (98).

Repeat this step for the other Arm Pad (not shown).

49.Insert the Barbell (35) through the Right and Left Guides (39, 38). Attach the Left Barbell Adapter

(36)to the Barbell with an M8 x 63mm Bolt (118), two M8 Washers (95), and an M8 Nylon Locknut

Attach the Right Barbell Adapter (not shown) in the same way.

47
72
106
98
106
98
73
29
48
52
98	113
98
74
49
39
35
38	118
	118
	95
	36
97	95
97

23

Image 23

Contents Mon.-Fri., 6 a.m.-6 p.m. MST QUESTIONS?Model No. WEBE4496.0 Serial No Call TOLL-FREETable of Contents Important Precautions Before YOU Begin Assembled DimensionsPart Identification Chart a Part Identification Chart B Do not tighten the Nylon Locknuts yet AssemblyMake Assembly Easier Screws yet See steps 1 and 2 and tighten the M10 Nylon LocknutsLocknuts yet Make sure the Short Pin is engaged in an adjustment hole Repeat this step for the other Front Base 116 100 Repeat this step for the other Storage Tube 116 133 100 125 132 124 Notch Do not tighten the Nylon Locknut yet Repeat this step for the other side of the weight benchRepeat this step for the Left Butterfly Arm Make sure the Adjustable Pulley Plate is ori Ented as shownLocknuts 94. Do not tighten the Nylon Center Frame Make sure the flat edge of the Cable is againstLocknut 94. Make sure the Half Guards are Oriented as shown Swivel Arm Page Make sure the Spacers are inside the Swivel Arm Swivel Arm. Make sure the Cable is routed Under the bar in the Swivel Arm Locate the Low Cable 58. Route the Cable Page Attach the Right Barbell Adapter not shown in the same way Repeat this step for the other Arm Pad not shownShort Pin engages a hole in the Backrest Frame AdjustmentAdjusting the Backrest Attaching the Curl Post Adding Weight to the LEG LeverAttaching the Accessories Using the BarbellAdjusting the Weight Rests and the Squat Safety Spotters Tightening the Cables Using the VKR ARMUsing the Butterfly Arms Cable Diagram Exercise Guidelines Staying Motivated Muscle ChartCooling Down Qty Description Part LIST-Model No. WEBE4496.0111 R1006A Exploded Drawing B-Model No. WEBE4496.0 R1006A Exploded Drawing C-Model No. WEBE4496.0 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty