Miele T 4422 C Problem Possible cause Remedy Condenser unit, Service panel will, Not shut

Problem solving guide

Problem	Possible cause	Remedy
The condenser unit	The inner cover of the	– Ensure that the condenser
service panel will	condenser unit has not	unit is positioned correctly
not shut.	been locked properly	and lock the cover.
	and/or the condenser unit	– Check the rubber seals.
	has not been positioned
	correctly.
Water leaks from the	Fluff has collected at the	– Use a cloth to remove any
machine after the	bottom of the condenser	fluff from the inside of the
condenser unit has	unit housing.	condenser unit housing.
been cleaned.
The interior drum	The lighting switched off	The lighting only comes on
lighting does not	automatically.	when the door is opened if
come on.		the dryer is switched on. To
		save energy the lighting
		goes out after a while if the
		door is left open.
	The lamp needs changing.	Change the lamp as
		described at the end of this
		section.
The ring around the	The lighting switched off	It lights up when drying is in
programme selector	automatically.	progress and goes out
does not light up.		shortly after the end of the
		programme to save energy.
Check and fault indicator lamps
Problem	Possible cause	Remedy
The Anti-crease /	The programme selector	Turn the selector back to the
Finish indicator	was moved after the start	original position and the
lamp flashes while	of a programme. The	indicator lamp will go out.
drying is in	programme continues to
progress.	run as normal.
The Locked	The system lock is	If you wish to use the dryer,
indicator lamp	activated.	the system lock must be
flashes when the		deactivated (see "Electronic
machine is switched		system lock").
on and the
programme cannot
be started.

30