Installation
Aligning the machine
The machine must be perfectly level to ensure safe and proper operation.
^The screw feet can be adjusted to compensate for any unevenness in the floor.
,The ventilation gaps in the plinth must not be covered over as this would prevent a sufficient intake of air.
Room in which the dryer is located
Air taken in for use in the drying process will be warm when it is expelled from the rear of the dryer. This expelled air heats up the air in the room. It is therefore very important to ensure that the room is adequately ventilated, particularly if the dryer is located in a small room. Otherwise running times and energy consumption could be increased.
Washer - dryer stack
The tumble dryer can also be combined with a Miele washing machine in a
*Available as an optional accessory from your Miele dealer or the Miele Spare Parts Department.
Stacking kits must be fitted by a suitably qualified fitter.
Before moving the machine again (e.g. when moving house)
After each use a small quantity of condensed water will collect in the area around the pump. This water can run out if the machine is tipped up when it is being moved. It is a good idea to run the Cool air programme for approximately 1 minute before moving the machine. Any remaining condensed water will then be fed into the condensed water container or out through the drain hose.
37