Miele T 4422 C Problem Possible cause Remedy Programme has, Been interrupted, Flashing, Following

Problem solving guide

Problem	Possible cause	Remedy
The programme has	No obvious cause.	– Switch the dryer off and
been interrupted,		then on again.
the indicator lamp		– Then start the programme
for Hand iron or		again.
Machine iron is		If the programme stops
flashing, and the
		again and an indicator lamp
buzzer sounds.
		flashes, there is a fault.
		Contact the Miele Service
		Department.
Check and fault indicator messages in the display
After the beginning	This is not a fault.	The electronic unit is
of the programme		calculating the drying time
the following		for the programme (see
symbols flash in the		“Guide to the appliance”).
display: "=== ... -== ...
== ... ".
Shortly before the	This might be because:	The drying process is not
end of the	– items of laundry may	yet complete. The
programme, the	have rolled up together.	programme needs more
count down of the	– the types of fabrics being	time than the electronic unit
time left to run halts	dried may take different	calculated at the start of the
at 11 or 6, horizontal		programme. The time count
	times to dry.
bars flash but the		down is suspended until the
	– the fluff filters are
dryer continues to		degree of drying selected
	clogged.
dry.		has been reached.
	– the temperature in the
	room may have
	changed.
The programme has	This is not a fault. The	Use the "Timed drying -
been stopped, the	electronic unit has	Warm air" programme to dry
Anti-crease/Finish	recognised that there is no	individual items.
lamp comes on, 0	laundry in the drum and	Before changing a
appears in the	cancelled the programme.	programme: Open and
display and the	Drying individual garments	close the drum door.
buzzer sounds.	or items which are already
	dry can also cause the
	programme to be stopped.

32