Miele T 4422 C operating instructions Cleaning and care, Emptying the condensed water container

Page 21

Cleaning and care

Emptying the condensed water container

The condensed water will be collected in the condensed water container unless the machine has been fitted with a drain hose (see installation).

The condensed water container should be emptied after every drying cycle or as soon as the Empty out container indicator lamp comes on.

The drying programme will be interrupted if the maximum level of the condensed water container is reached. The Empty out container indicator lamp comes on and the buzzer sounds.

^Grip the container firmly with both hands, as shown, and pull it out slightly towards the right-hand side.

^Hold the container with both hands and carry it in a horizontal position.

^Open the shutter and empty out the water.

^To replace the container hold it at a slight angle (as when removing it) and push it in gently until you feel it click into position.

^Before starting a new programme, first switch the machine off and then on again. The Empty out container indicator lamp will go out.

Condensed water should not be consumed. It could lead to health problems for people and animals.

Condensed water can be put to household use (e.g. used in a steam iron or humidifier). To ensure that any residual particles of fluff in the condensed water are removed before use, pass it through a fine sieve or paper filter first.

21

Image 21
Contents Operating instructions For condenser tumble dryer T 4422 C Contents Contents Correct use Technical safetyOperation Using accessories Disposal of the packing material Caring for the environmentDisposal of your old machine Energy saving tipsDAdditional option buttons Indicator lamps Control panel / FeaturesGuide to the appliance DisplayFuture updates Time left display for Cottons and Minimum Iron programmesElectronic lock and programmable functions Wash care labels Tips on dryingProgramme chart Programme Fabric type Special notes Warm airCool air Smoothing Hand careHow to dry correctly Load the drum and switch on the dryerPrepare the laundry Anti-crease Selecting a programme Selecting additional optionsLow temperature Delay startShort BuzzerStarting a programme Clean out airways indicator lampAfter drying Additional notesBrief instructions To change a programme To cancel a programme and select a different programmeTo interrupt a programme Adding or removing itemsElectronic system lock To activate the system lockTo de-activate the system lock Emptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryerRemoving the condenser unit Cleaning the condenser unitChecking the condenser unit Cleaning the condenser unitReplacing the condenser unit Problem solving guide Fluff Problem Possible cause Remedy There is a build upLaundry is not Sufficiently dryProblem Possible cause Remedy Drying process Even switches offGoes on too long or Service panel will Problem Possible cause Remedy Condenser unitBeen cleaned Interior drum Finish indicatorStops and the Clean Problem Possible cause RemedyAirways lamp comes FlashesSymbols flash Problem Possible cause Remedy Programme hasBeen interrupted Flashing,To change the interior drum lamp Future updates PC After sales serviceOptional accessories RepairsFront view InstallationInstallation site Transporting the machine to its installation siteReplacing the lid Aligning the machine Before moving the machine again e.g. when moving houseRoom in which the dryer is located Washer dryer stackPulling out the drain hose External condensed water outletConnection to a sink drain outlet Electrical connection U.K. Non-rewireable plugs BS Electrical connectionElectrical connection U.K Must be Earthed Cottons Consumption dataTechnical data Page Programmable functions for changing standard settings Increased drying level Programmable functionsProgramming and storing in memory To checkMemory Alteration rights reserved/0504