GE WBVH5100, GCVH6600, GHDVH626, GHDVH670 Unpacking the Washer, Save all bolts for future use

Installation Instructions

UNPACKING THE WASHER

WARNING: Recycle or destroy the carton and plastic bags after the washer is unpacked. Make materials inaccessible to children. Children might use them for play. Cartons covered with rugs, bedspreads or plastic sheets can become airtight chambers causing suffocation.

1.Cut and remove the top and bottom packaging straps.

2.While it is in the carton, carefully lay the washer on its side. DO NOT lay the washer on its front or back.

3.Turn down the bottom flaps—remove all base packaging, including the cardboard, styrofoam base and styrofoam tub support (inserted in center of base). Save the stacking brackets located on the styrofoam pad that covered the top of the washer.

NOTE: If you are installing a pedestal, proceed to the installation instructions that come with the pedestal.

4.Carefully return the washer to an upright position and remove the carton.

5.Carefully move the washer to within 4 feet (122 cm) of the final location.

6.Remove the following from the back side of the washer: 4 bolts

4 plastic spacers (including rubber grommets)

4 power cord retainers

NOTE: Failure to remove the shipping braces can cause the washer to become severely unbalanced.

Save all bolts for future use.

NOTE: If you must transport the washer at a later date, you must reinstall the shipping support hardware to prevent shipping damage. Keep the hardware in the plastic bag provided.

16