Amana RS3100007 service manual Temperature and Speed Switch

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to unit before servicing.

Before attaching wire harness terminal blocks to timer, verify all male terminals on timer are straight and are capable of accepting terminals from wire harness terminal blocks.

NOTE: When installing timer, verify timer is installed correctly and is securely mounted to control mounting plate.

!CAUTION

To avoid risk of timer damage, do not allow timer to be struck on the corners, edges of frame, or on timer shaft.

Temperature and Speed Switch

1.Loosen control hood assembly, see “Control Hood Assembly” procedure steps 1 and 2.

2.Slide a soft cloth under the knob, wrapping the entire knob and pull gently away from the control panel.

3.Disconnect wires from switch terminals.

4.From the front, press inward on black plastic tabs next to the switch shaft and rotate switch to release switch from control hood mounting plate.

5.Reverse procedure to reassemble.

NOTE: See appropriate wiring diagram when rewiring components.

		Top		Screws
				Temperature
		cover
				switch
		Screw			Pressure
		End panel			switch
		(left side)			Screw
					Speed
					switch
	Control	Screw			Timer
	knob
				Screw
			Ground		Screw
			clip
Rocker
switch			Control
		Timer
			mounting
	Timer	knob
			plate
	knob	skirt
					End panel
		Screw
					(right side)
	Graphic		Hold-down	Control hood
				rear panel	Screw
	panel		clip
		Typical Control Panel Assembly
RS3100007	Rev. 0		18