Amana RS3100007 service manual Component Testing Information, Component Test Procedure Results

Component Testing Information

!WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless testing requires it.

Illustration	Component		Test Procedure		Results
	Rocker switch	Measure resistance of switch
	(Extra Rinse)	positions:		Continuity	>1 Ω
		Closed	(ON position)	Infinite	Ω
		Open	(OFF position)		1 M
	Indicator light	Measure voltage at indicator light.		If line voltage is present and light does
				not work replace light.
				If no voltage is present at indicator light
				check wiring.
	Signal switch	Measure resistance of the switch
		turned to LOUD position.		Nominal 1155 Ω ± 5%

Temperature switch	Disconnect wires from component to
	properly measure the resistance of the
2	component.
	Place switch in the following positions
1
	and measure across the terminals
	below:

					Hot / Cold	L1-2⎯⎯⎯⎯⎯⎯⎯	>1 Ω
	L1	L2
					Warm / Warm	L1-1, L1-2, L2-2
						L2-1, L2-L1, 1-2⎯⎯	>1 Ω
					Warm / Cold	L1-1, L1-2, 1-2⎯⎯⎯	>1 Ω
					Cold / Cold	L1-1⎯⎯⎯⎯⎯⎯⎯	>1 Ω
				Speed switch	Disconnect wires from component to
					properly measure the resistance of the
2					component.
					Place switch in the following positions
			C
					and measure across the terminals
					shown below:
					Reg / Fast	L1-C, L2-C⎯⎯⎯⎯⎯	>1 Ω
	L1	L2
					Reg /Slow	L1-C, L2-2⎯⎯⎯⎯⎯	>1 Ω
					Gentle / Fast	L1-2, L2-C⎯⎯⎯⎯⎯	>1 Ω
					Gentle / Slow	L1-2, L2-2⎯⎯⎯⎯⎯	>1 Ω
				Mixing valve	Measure resistance of terminals on
					each valve.
					Resistance across each valve.		Approximately 1000 Ω ± 10%

Timer

Verify input and output voltage is present.

Refer to specific model Technical Sheet for timing sequence chart and functional description of the component.

7 RS3100007 Rev. 0