American Dryer Corp EURO-24 manual Microprocessor computer display reads dSFL

Page 51

3.Failed arc suppressor (A.S.) board (for Reversing Models ONLY).

4.Failed microprocessor controller (computer).

5.Failed 24 VAC transformer.

H.Both drive motor and blower motor run a few minutes and then stop...microprocessor controller (computer) display continues to read time or percent of extraction and all indicator dots are off...

1.Fault in main door switch circuit ...

a.Failed main door switch.

b.Main door switch out of adjustment.

c.Loose connection in door switch circuit.

2.Fault in lint drawer switch circiut ...

a.Lint drawer switch out of proper adjustment.

b.Loose connection in the lint drawer switch circiut.

I.Microprocessor (computer) display reads "dSFL"...

1.Fault in microprocessor heat sensing circuit ...

a.Failed microprocessor temperature sensor.

b.Failed microprocessor controller (computer).

c.Broken wire or connection somewhere between the microprocessor controller (computer) and the microprocessor temperature sensor.

J.Microprocessor controller (computer) display reads "door"...

1.Fault (open circuit) in the main door or Lint drawer switch circuit ...

a.Lint drawer is not closed all the way.

b.Lint drawer switch out of proper adjustment.

c.Failed lint drawer switch. d. Failed main door switch.

e. Broken connection/wire in main door circuit.

2. Failed 24 VAC transformer.

47

Image 51

Contents EURO-24 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Routine Maintenance Important Information SectionPersonal Injury or Fire could Result Safety PrecautionsStandards Specifications SpecificationsSpecifications UNPACKING/SETTING UP Installation ProceduresLocation Requirements Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Important Venting Reminders Electrical Information Must be Provided Black White Green Neutral Important a Circuit Serving Each Dryer Must be Provided Important a Circuit Serving Each Dryer Must be Provided EURO-24 GAS EURO-24 Steam Electrical Service Specifications PER DryerInjury and Improper Operation of the Dryer GAS Information14.92 29.9 mb 26.1 mbPage Page 862 KPa Steam InformationPage Compressed AIR Supply AIR Pressure Page Steam Damper Air Piston Flow Control Operation Adjustment Preparation for OPERATION/START-UP GAS Models only Preoperational TestsBasket Coating Preoperational InstructionsPage OPL Models Shut Down Instructions SERVICE/PARTS Information ServiceParts Returning Warranty Parts Warranty InformationReturning Warranty Cards WarrantyPage Cleaning Routine MaintenanceLubrication AdjustmentsLint Drawer Removal Troubleshooting No L.E.D. light emitting diode displayDrive motor not operating does not start Blower motor not operating does not start Microprocessor controller computer display reads door Microprocessor computer display reads dSFLPage Failed oven contactor/relay Failed heat selector switch Condensation on main door glass Dryer operates but is taking too long to dryExcessive noise and/or vibration Scraping noise from basket tumbler areaHeating unit not operating ALL temperature selections Drive motor only not operatingBlower motor only not operating Dryer operates but is taking too long to dry load Heat unit not operating for only one 1 temperature selectionSail switch is fluttering for GAS and Electric Models only Data Label Technical InformationData Label Timing Legend Reversing Timer SPIN/DWELL AdjustmentsProcedure for Functional Check Replacement Components Page ADC 08/03/99-25 01/18/00-25 07/14/00-20