American Dryer Corp EURO-24 manual Failed oven contactor/relay Failed heat selector switch

Page 53

P. Heating unit is not operating (no heat) and heat indicator dot is on...

GAS MODELS ONLY

1.Fault in sail switch circuit ...

a.Sail switch is out of adjustment or has failed.

b.Sail switch damper is not closing or is fluttering ...

1)Lint drawer/screen is dirty.

2)Restriction in exhaust.

2.Fault in burner hi-limit circuit or tripped manual thermostat.

3.Tripped lint chamber sensor bracket manual reset hi-heat protector thermostat.

4.Failed Hot Surface Ignition (HSI) module.

5.Failed HSI (Hot Surface Ignition) ignitor/flame-probe.

6.Failed microprocessor controller (computer).

ELECTRIC MODELS ONLY

1.Fault in sail switch circuit ...

a.Sail switch out of adjustment and/or failed.

b.Sail switch not closing or fluttering ...

1)Check blower (impellor/fan) motor and rotation direction.

2)Restriction in location exhaust system.

2.Failed oven hi-limit circuit.

3.Tripped lint compartment manual reset (225º F [107º C]) safety thermostat circuit.

4.Failed oven contactor/relay.

5.Failed heat selector switch.

STEAM MODELS ONLY

1.Tripped lint chamber sensor bracket manual reset hi-heat (limit) protector thermostat.

2.Failed microprocessor controller (computer).

49

Image 53

Contents EURO-24 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Routine Maintenance Important Information SectionPersonal Injury or Fire could Result Safety PrecautionsStandards Specifications SpecificationsSpecifications UNPACKING/SETTING UP Installation ProceduresLocation Requirements Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Important Venting Reminders Electrical Information Must be Provided Black White Green Neutral Important a Circuit Serving Each Dryer Must be Provided Important a Circuit Serving Each Dryer Must be Provided EURO-24 GAS EURO-24 Steam Electrical Service Specifications PER DryerInjury and Improper Operation of the Dryer GAS Information14.92 29.9 mb 26.1 mbPage Page 862 KPa Steam InformationPage Compressed AIR Supply AIR Pressure Page Steam Damper Air Piston Flow Control Operation Adjustment Preparation for OPERATION/START-UP GAS Models only Preoperational TestsBasket Coating Preoperational InstructionsPage OPL Models Shut Down Instructions Parts SERVICE/PARTS InformationService Returning Warranty Cards Warranty InformationWarranty Returning Warranty PartsPage Cleaning Routine MaintenanceLubrication AdjustmentsLint Drawer Removal Drive motor not operating does not start TroubleshootingNo L.E.D. light emitting diode display Blower motor not operating does not start Microprocessor controller computer display reads door Microprocessor computer display reads dSFLPage Failed oven contactor/relay Failed heat selector switch Condensation on main door glass Dryer operates but is taking too long to dryExcessive noise and/or vibration Scraping noise from basket tumbler areaBlower motor only not operating Heating unit not operating ALL temperature selectionsDrive motor only not operating Dryer operates but is taking too long to dry load Heat unit not operating for only one 1 temperature selectionSail switch is fluttering for GAS and Electric Models only Data Label Technical InformationData Label Timing Legend Reversing Timer SPIN/DWELL AdjustmentsProcedure for Functional Check Replacement Components Page ADC 08/03/99-25 01/18/00-25 07/14/00-20