American Dryer Corp Super AD-30 manual Microprocessor computer display reads dSFL

Page 50

3.Failed arc suppressor (A.S.) board (for Reversing Models ONLY).

4.Failed microprocessor controller (computer).

5.Failed 24 VAC transformer.

H.Both drive motor and blower motor run a few minutes and then stop...microprocessor controller (computer) display continues to read time or percent of extraction and all indicator dots are off...

1.Fault in main door switch circuit ...

a.Failed main door switch.

b.Main door switch out of adjustment.

c.Loose connection in door switch circuit.

I.Microprocessor (computer) display reads "dSFL"...

1.Fault in microprocessor heat sensing circuit ...

a.Failed microprocessor temperature sensor.

b.Failed microprocessor controller (computer).

c.Broken wire or connection somewhere between the microprocessor controller (computer) and the micro-processor temperature sensor.

J.Microprocessor controller (computer) display reads "door"...

1.Fault (open circuit) in door switch circuit ...

a.Failed main door switch.

b.Broken connection/wire in main door circuit.

2.Failed 24 VAC transformer.

K.Microprocessor controller (computer) will not accept any keyboard entries, i.e., L.E.D. (light emitting diode) display reads "FILL" and when keyboard entries are selected, the L.E.D. display continues to read "FILL"...

1.Failed keyboard label (touchpad) assembly.

2.Failed microprocessor controller (computer).

L.Microprocessor controller will only accept certain keyboard entries ...

1.Failed keyboard label (touchpad) assembly.

2.Failed microprocessor controller (computer).

46

Image 50

Contents Super AD-30 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Troubleshooting Section Important InformationSafety Precautions What to do if YOU Smell GASPage Super AD-30 Specifications SpecificationsSpecifications Installation Procedures UNPACKING/SETTING UPLocation Requirements Section DDryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Important Venting Reminders Electrical Information Page Green Phase 3ø Hookup for GAS and Steam Dryers only Page Super ADG-30DS Gas Reversing Super ADS-30DS Steam Reversing GAS Information Piping/Connections Page Page Steam Information Page 90 psi Normal 80 psi70 psi Page Preparation for Operation Preoperational Tests Page Preoperational Instructions Page OPL Models Shut Down Instructions Parts SERVICE/PARTS InformationService Warranty Warranty InformationReturning Warranty Cards Returning Warranty PartsPage Routine Maintenance CleaningAdjustments LubricationDrive motor not operating does not start TroubleshootingNo L.E.D. light emitting diode display Blower motor not operating does not start Microprocessor computer display reads dSFL Microprocessor controller computer display reads doorPage No heat for Steam Models only Dryer operates but is taking too long to dryExcessive noise and/or vibration Condensation on main door glassDryer or scraping noise at basket tumbler area Drive motor only not operating Blower motor only not operatingHeating unit not operating ALL temperature selections Heat unit not operating for only one 1 temperature selectionDryer operates but is taking too long to dry load Failed hi-limit thermostat for GAS and Electric Models onlyPage Reversing Timer SPIN/DWELL Adjustments Timing LegendContact American Dryer Corporation Technical InformationData Label Data Label Procedure for Functional Check Replacement Components Microprocessor computer BoardDirect Spark Ignition DSI System