American Dryer Corp Super AD-30 Drive motor only not operating, Blower motor only not operating

Page 54

2.Insufficient make-up air.

3.Dust and/or lint in burner.

4.Insufficient gas pressure.

DUAL TIMER MODELS

A.Dryer will not start..both drive and blower motors not operating (indicator light is off)...

1.Dryer control circuit fuse is blown.

2.Open at location...service main fuse or circuit breaker.

3.Failed push to start relay.

4.Failed door switch and/or circuit.

5.Failed heat timer.

6.Failed dual timer relay.

B. Drive motor (only) not operating ...

1.Failed drive motor contactor.

2.Failed reversing timer (for Reversing Models Only).

3.Failed drive motor.

C.Blower motor (only) not operating...

1.Failed impellor (blower/fan) motor contactor (relay).

2.Failed blower (impellor/fan) motor.

D.Both drive and blower motors not operating (indicator light is on)...

1.Fault with L1 termination at reversing timer (for Reversing Models Only).

E.Reversing drive motor operates in one direction only, stops, and restarts in same direction (for Reversing Models Only)...

1.Failed reversing contactor (relay).

2.Failed reversing timer.

50

Image 54
Contents Super AD-30 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Troubleshooting Section Important InformationSafety Precautions What to do if YOU Smell GASPage Super AD-30 Specifications SpecificationsSpecifications Installation Procedures UNPACKING/SETTING UPLocation Requirements Section DDryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Single Dryer Venting Illus. B Multiple Dryer Common Venting ILLUS. D Important Venting Reminders Electrical Information Page Green Phase 3ø Hookup for GAS and Steam Dryers only Page Super ADG-30DS Gas Reversing Super ADS-30DS Steam Reversing GAS Information Piping/Connections Page Page Steam Information Page Normal 80 psi 70 psi90 psi Page Preparation for Operation Preoperational Tests Page Preoperational Instructions Page OPL Models Shut Down Instructions SERVICE/PARTS Information ServiceParts Warranty Warranty InformationReturning Warranty Cards Returning Warranty PartsPage Routine Maintenance CleaningAdjustments LubricationTroubleshooting No L.E.D. light emitting diode displayDrive motor not operating does not start Blower motor not operating does not start Microprocessor computer display reads dSFL Microprocessor controller computer display reads doorPage No heat for Steam Models only Dryer operates but is taking too long to dryCondensation on main door glass Dryer or scraping noise at basket tumbler areaExcessive noise and/or vibration Drive motor only not operating Blower motor only not operatingHeating unit not operating ALL temperature selections Heat unit not operating for only one 1 temperature selectionDryer operates but is taking too long to dry load Failed hi-limit thermostat for GAS and Electric Models onlyPage Reversing Timer SPIN/DWELL Adjustments Timing LegendTechnical Information Data LabelContact American Dryer Corporation Data Label Procedure for Functional Check Replacement Components Microprocessor computer BoardDirect Spark Ignition DSI System