Chromalox CN2110 manual Exit Configuration, 5Move to .6until SP is next menu Displayed

CN 2110 Temperature Controller

Configuration

continued

4.Press the or buttons to adjust the value (only the value is dis- played during adjustment). See Figure 4.7. The new value is set when the or button is released.

5.Press and hold the Set Point () button and press the button to advance to the next menu. See Figure 4.8. (Holding the Set Point

() button and pressing the button moves through menus in the opposite direction.)

Repeat steps 4 and 5 through the configuration menus.

Load	¡F	Load	¡F
Alarm	¡C	Alarm	¡C
Temp	Set Point	Temp	Set Point

Set	Set
Point	Point

Figure 4.3		Figure 4.4	Adjust lock
			to 458
Load	¡F	Load	¡F
Alarm	¡C	Alarm	¡C
Temp	Set Point	Temp	Set Point
Set		Set
Point		Point

Continue

Figure 4.5Move to Figure 4.6until SP is next menu

displayed

Load	°F	Load	¡F
Alarm	°C	Alarm	¡C
Temp	Set Point	Temp	Set Point

Set	Set
Point	Point

Figure 4.7 Adjust the	Figure 4.8	Continue
		through the
set point
		configuration
value
		menus

Exit Configuration

To exit configuration mode, press and hold both the and buttons for three seconds to return to the operation mode.

Note: If no buttons are pressed for three minutes while in user configu- ration mode, then the controller will exit user configuration and return to the operation mode.

Section 4–Adjusting Set Point and Configuration 13 CN 2110