Chromalox CN2110 manual Removing Mounting Collars

Page 9

CN 2110 Temperature Controller

Mounting	Two mounting collars securely hold the CN 2110 controller in the
	mounting hole. Remove these mounting collars before installation.

Removing Mounting Collars

1.To remove the rear collar, press the sides of the collar. This releases holding tabs on the top and bottom of the collar.

2.Slide the collar off the back of the unit.

3.Slide the front collar off the back of the unit

Press In

Front Collar	Holding
	Tabs
Rear Collar
Press In

Figure 3.2

Removing Mounting Collars

continued

Section 3–Installation and Wiring

5

CN 2110

Image 9

Contents User’s Guide Omega.com Table of Contents CN 2110 Temperature ControllerPage Quick Setup Setting the Sensor and Control ModeAdjusting the Set Point Inspection and Unpacking IntroductionModel Identification Sensor and Control Type Selection Switches Installation and WiringRemoving Mounting Collars MountingController will now be held firmly in place Mount the CNGood Wiring Practices Thermocouple Inputs Sensor Input Wiring Sensor Wiring NotesSensor Input Wiring Three-Wire RTD InputsTwo-Wire RTD Inputs Control Output Wiring R20 20 Amp Relay Output WiringDC Solid State Relay Drive, 24Vdc, 40mA Output Wiring Instrument Power Wiring Adjusting Set Point and Configuration Adjusting the Set PointConfiguration 5Move to .6until SP is next menu Displayed Exit ConfigurationSecurity Codes and Levels Configuration MenusOFF Control and Alarm Operation Control Operation Alarm Operation optionalTuning PI Control Replacing Output Modules Module InstallationModule Option Descriptions RemovalAuto Cycle Time ReplacementCalibration Offset Factory Default Recovery To reestablish the factory default valuesCalibration Calibration Factory Calibration Recovery Calibration NotesSensor Calibration Control Adjustments SpecificationsSymptom Probable Cause Correction Steps TroubleshootingFAn FAIL, CN TroubleshootingPage Page Page USAWARRANTY/DISCLAIMER Temperature