Chromalox CN2110 manual CN 2110 Temperature Controller, Table of Contents

CN 2110 Temperature Controller

Table of Contents

Manual Sections

1–Quick Setup	1
2–Introduction	2
3–Installation and Wiring	4
4–Adjusting Setpoint and Configuration	12
5–Controller and Alarm Operation	16
6–Replacing Output Modules	17
7–Calibration	19
8–Specifications	21
9–Troubleshooting	22
10–Omega Warranty and Return	24

Illustrations	1.1	Dip Switch Settings	1
	1.2	Establishing the Set Point	1
	1.3	Adjusting the Set Point	1
	2.1	Front Panel Identification	2
	2.2	Typical Application	3
	2.3	Model Identification	3
	3.1	Default Dip Switch Settings	4
	3.2	Removing Mounting Collars	5
	3.3	Mounting Dimensions	6
	3.4	Mounting the CN 2110	6
	3.5	Wiring Terminal Identification	7
	3.6	Thermocouple Connections with Shield	8
	3.7	Three-Wire RTD Connections with Shield	9
	3.8	Two-Wire RTD Connections	9
	3.9	Control Output Wiring–R1 and TI	10
	3.10	Control Output Wiring–R20	10
	3.11	Control Output Wiring–DC	10
	3.12	Control Output Wiring–T5 and T10	11
	3.13	90-260 VAC Instrument Power Connections	11
	3.14	Alarm Connections	11
	4.1	Establishing the Set Point	12
	4.2	Adjusting the Set Point	12
	4.3	Configuring CN 2110	13
	4.4	Configuring CN 2110	13
	4.5	Configuring CN 2110	13
	4.6	Configuring CN 2110	13
	4.7	Configuring CN 2110	13
	4.8	Configuring CN 2110	13
	6.1	Replacing Output Module	18

iii CN 2110