Intermec PRO 128 manual Raw Sonar ID+ On

Page 19

USING THE TRACKER UNIT

MENU FUNCTIONS

Fish ID. There are three selections available: OFF, ID+ ON, and ADJUST. The fac- tory setting is ID+ ON. With Fish ID OFF, sonar returns are displayed as “raw” information. There is no interpretation made by the unit. Selecting ID OFF also disables the fish alarm.

ID+ ON enables the Tracker unit to interpret the raw sonar data and, using a variety of techniques, depict appropriate target returns as one of three different size fish symbols. Further identification shows whether the fish is in the wide or narrow beam. The Tracker unit also displays the depth beneath the surface with the corresponding fish symbol.

Selecting Adjust and making incremental changes enhances the fishfinder’s ability to identify sonar returns as fish symbols.

Increasing the value to a number greater than zero shows more fish symbols on-screen. In

this case smaller sonar returns will be depicted

as fish symbols. This is useful for identifying

many smaller sonar returns (such as baitfish)

as fish symbols.

Decreasing the value to a number less than zero

shows fewer fish symbols on-screen. In this case

smaller sonar returns are disregarded. This is

useful for eliminating many small sonar returns when seeking larger species of fish.

Raw Sonar

ID+ On

The Tracker unit remembers this selection even when the unit is powered off.

Numeral Size. Two options are available: BIG and SMALL. The factory setting is BIG. With this setting, the

digital depth and speed and temp

numerals are

drawn large

enough to be read from across

17

Image 19

Contents PRO 128 Fishfinder Thank YOU Table of Contents HOW Sonar Works Using the Tracker UnitHOW Sonar Works Simulator Operation Feature MemorySimulator Operation What You See On-Screen What YOU see ON-SCREENSurface Clutter Rocky Bottom Soft Bottom Hard Bottom Thermoclines. Thermoclines are sharp What YOU see on ScreenID+ adds an additional piece of informa Control FunctionsControl Functions Al seconds until a continuous chirp is heard Menu Functions To the user Menu FunctionsUsing the Tracker Unit Depth Range User controls the location of the Zoom range Right side of the display. Zoom can either operateUsing the Tracker Unit Set, and Reset Excess of 20 or less than 10 VDC cause the unit to power offBottom Black. There are two selections Available OFF and ON. The factory setting isOFF. With this setting, the Tracker unit dis Black setting when powered offRaw Sonar ID+ On Numeral Size settings are remembered when powered off Using the Diagnostic Feature Using the Diagnostic FeatureMaintenance Advanced FeaturesMAINTENANCE/TROUBLESHOOTING Maintenance and WarrantyTroubleshooting There is no bottom reading visible on the display TroubleshootingNothing happens when I turn the unit on There is no transducer detectedGet gaps in the reading at high speeds Unit comes on before I press POWER, and won’t turn offMy unit loses power at high speeds TROUBLESHOOTING/WARRANTYHumminbird ONE Year Full Warranty Service Policy Warranty and Service PolicyFurther information on Humminbird products can be found at Transducer along with your unit when sending for repairCustomer Support Customer SupportTOP Remove and use for Transducer InstallationPage Specifications