Intermec PRO 128 manual Top, Remove and use for Transducer Installation

Page 29

TOP

Use 5⁄₃₂” (4.0mm) drill bit

DrillDrill

ALIGN ONE CORNER WITH LOWER EDGE OF TRANSOM

Remove and use for Transducer Installation

Image 29

Contents PRO 128 Fishfinder Thank YOU Table of Contents HOW Sonar Works Using the Tracker UnitHOW Sonar Works Simulator Operation Feature MemorySimulator Operation What You See On-Screen What YOU see ON-SCREENSurface Clutter Rocky Bottom Soft Bottom Hard Bottom Thermoclines. Thermoclines are sharp What YOU see on ScreenControl Functions Control FunctionsID+ adds an additional piece of informa Al seconds until a continuous chirp is heard Menu Functions To the user Menu FunctionsUsing the Tracker Unit Depth Range User controls the location of the Zoom range Right side of the display. Zoom can either operateUsing the Tracker Unit Set, and Reset Excess of 20 or less than 10 VDC cause the unit to power offOFF. With this setting, the Tracker unit dis Available OFF and ON. The factory setting isBlack setting when powered off Bottom Black. There are two selectionsRaw Sonar ID+ On Numeral Size settings are remembered when powered off Using the Diagnostic Feature Using the Diagnostic FeatureMaintenance Advanced FeaturesTroubleshooting Maintenance and WarrantyMAINTENANCE/TROUBLESHOOTING Nothing happens when I turn the unit on TroubleshootingThere is no transducer detected There is no bottom reading visible on the displayGet gaps in the reading at high speeds Unit comes on before I press POWER, and won’t turn offHumminbird ONE Year Full Warranty TROUBLESHOOTING/WARRANTYMy unit loses power at high speeds Service Policy Warranty and Service PolicyCustomer Support Transducer along with your unit when sending for repairCustomer Support Further information on Humminbird products can be found atTOP Remove and use for Transducer InstallationPage Specifications