Intermec PRO 128 manual Unit comes on before I press POWER, and won’t turn off

Page 25

MAINTENANCE AND WARRANTY

TROUBLESHOOTING

the digital depth readout is working but there is no bottom visible on-screen, it is possible the depth range has been adjusted manually to a range lower than what is needed to display the bottom. Also, in very deep water, it may be nec- essary to manually increase the sensitivity setting to maintain a graphic depiction of the bottom.

If you are using a transducer switch to connect two transducers to the Tracker unit, ensure the switch is in the correct position to connect a transducer that is in water. (If a trolling motor transducer is selected and the trolling motor is out of water, no sonar information appears.)

If none of the above solve the problem, inspect the transducer cable from end to end for breaks, kinks, or cuts in the outer casing of the cable. If the transducer is connected to the unit through a switch, temporarily connect it directly to the unit and try again. If none of these items identifies an obvious problem, the transducer itself may be the problem. Be sure to include the transducer if return- ing the unit for repair.

4.When in very shallow water, I get gaps in the bottom reading and inconsistent digital depth indication.

The Tracker unit will work reliably in water 2' (.6m) or deeper. The depth is mea- sured from the transducer, not necessarily from the surface.

5. The unit comes on before I press POWER, and won’t turn off.

Check the transducer cable—if the outer jacket of the cable has been cut and the cable is in contact with bare metal, you need to repair the cut with electri- cal tape. If there is no problem with the cable, disconnect the transducer from the unit and see if the problem is corrected, to confirm the source of the prob- lem.

6. I get gaps in the reading at high speeds.

Your transducer needs adjusting. If the transducer is transom-mounted, there are two adjustments available to you—height, and running angle. Make small adjustments and run the boat at high speeds to determine the effect. It may take several tries to optimize high speed operation. This can also be a result of air or turbulence in the transducer location caused by rivets, ribs, etc.

23

Page 24 Page 26
Image 25
Page 24 Page 26
Contents PRO 128 Fishfinder Thank YOU Table of Contents HOW Sonar Works Using the Tracker UnitHOW Sonar Works Simulator Operation Feature MemorySimulator Operation What You See On-Screen What YOU see ON-SCREENSurface Clutter Rocky Bottom Soft Bottom Hard Bottom Thermoclines. Thermoclines are sharp What YOU see on ScreenID+ adds an additional piece of informa Control FunctionsControl Functions Al seconds until a continuous chirp is heard Menu Functions To the user Menu FunctionsUsing the Tracker Unit Depth Range User controls the location of the Zoom range Right side of the display. Zoom can either operateUsing the Tracker Unit Set, and Reset Excess of 20 or less than 10 VDC cause the unit to power offOFF. With this setting, the Tracker unit dis Available OFF and ON. The factory setting isBlack setting when powered off Bottom Black. There are two selectionsRaw Sonar ID+ On Numeral Size settings are remembered when powered off Using the Diagnostic Feature Using the Diagnostic FeatureMaintenance Advanced FeaturesMAINTENANCE/TROUBLESHOOTING Maintenance and WarrantyTroubleshooting Nothing happens when I turn the unit on TroubleshootingThere is no transducer detected There is no bottom reading visible on the displayGet gaps in the reading at high speeds Unit comes on before I press POWER, and won’t turn offMy unit loses power at high speeds TROUBLESHOOTING/WARRANTYHumminbird ONE Year Full Warranty Service Policy Warranty and Service PolicyCustomer Support Transducer along with your unit when sending for repairCustomer Support Further information on Humminbird products can be found atTOP Remove and use for Transducer InstallationPage Specifications
Top Page Image Contents