Intermec PRO 128 manual Numeral Size settings are remembered when powered off

Page 20

USING THE TRACKER UNIT

MENU FUNCTIONS

the boat. The big numerals occupy space on the display that could be used for the graphics area. Hence, the small numerals option. With small numer- als selected, a greater amount of the display area is available for the graph- ic view. This effectively increases the display resolution of the unit.

Numeral Size settings are remembered when powered off.

Diagnostic. Two options are available: HIDE and SHOW. The factory setting is HIDE. Selecting SHOW brings up the Diagnostic screen. See the Using Diag- nostic section for more information.

Units. The Units function allows the user to select the units of measurement for the depth and speed

readout. FEET/MPH (feet/statute miles per hour) and FEET/KTS (feet/nautical miles per hour), are available.The Tracker unit remembers this selection even

when the unit is powered off.

Speed Offset. The Speed Offset option allows

the user to compensate for differences in hull

design, and its effect on the accuracy of the

speed measurement.

If there is a discrepancy between the indicated speed and another speed measurement device on the boat, the speed measurement can be var- ied to improve accuracy. Remember, the speed paddle wheel measures speed through the water,

not speed over ground.

Speed offset is remembered after power is disconnected.

Depth Offset. The Depth Offset allows the user to select the point on the boat from which the depth measurement is made. Selecting a positive value adds distance to the measurement. If the transducer is mounted 3 feet beneath the water- line, a positive 3 will show the correct depth from the surface of the water.

18

Image 20
Contents PRO 128 Fishfinder Thank YOU Table of Contents HOW Sonar Works Using the Tracker UnitHOW Sonar Works Simulator Operation Feature MemorySimulator Operation What YOU see ON-SCREEN What You See On-ScreenSurface Clutter Rocky Bottom Soft Bottom Hard Bottom What YOU see on Screen Thermoclines. Thermoclines are sharpControl Functions Control FunctionsID+ adds an additional piece of informa Al seconds until a continuous chirp is heard Menu Functions Menu Functions To the userUsing the Tracker Unit Depth Range Right side of the display. Zoom can either operate User controls the location of the Zoom rangeUsing the Tracker Unit Excess of 20 or less than 10 VDC cause the unit to power off Set, and ResetAvailable OFF and ON. The factory setting is OFF. With this setting, the Tracker unit disBlack setting when powered off Bottom Black. There are two selectionsRaw Sonar ID+ On Numeral Size settings are remembered when powered off Using the Diagnostic Feature Using the Diagnostic FeatureAdvanced Features MaintenanceTroubleshooting Maintenance and WarrantyMAINTENANCE/TROUBLESHOOTING Troubleshooting Nothing happens when I turn the unit onThere is no transducer detected There is no bottom reading visible on the displayUnit comes on before I press POWER, and won’t turn off Get gaps in the reading at high speedsHumminbird ONE Year Full Warranty TROUBLESHOOTING/WARRANTYMy unit loses power at high speeds Warranty and Service Policy Service PolicyTransducer along with your unit when sending for repair Customer SupportCustomer Support Further information on Humminbird products can be found atRemove and use for Transducer Installation TOPPage Specifications