Intermec PRO 128 manual What YOU see ON-SCREEN, What You See On-Screen

Page 6

USING THE TRACKER UNIT

WHAT YOU SEE ON-SCREEN

If you are using the Tracker unit in Simulator when no transducer is con- nected, any selected options are lost when the unit is powered off. The Tracker unit will return to Factory Settings, or options selected when last used with a transducer, if no transducer is connected.

IMPORTANT: A transducer must be connected to the Tracker unit in order to retain user settings selected when in simulator mode. If no transducer is detected, the unit defaults to pre-selected options when powered off.

What You See On-Screen

Your Tracker unit uses a 128 V x 64 H matrix FSTN LCD display. This display provides outstanding viewability in all light conditions over a wide range of temperatures.

At initial power-up, the Tracker unit uses settings that were set at the factory. After initial use, the Tracker unit will remember the settings you enter.

There are several elements on-screen that are common to all modes of opera- tion.

Figure A

Temperature/Speed. The initial screen layout takes one of two basic forms depending on whether the optional Temp/Speed accessory is installed. Figure A shows the default view when the Temp/Speed accessory is installed. Figure B shows the default view when the Temp/Speed accessory is not installed.

Depth. The digital depth number shows the water depth directly beneath the transducer location.

Depth Range. The depth range is shown to the right of the screen. The upper number is 0 indicating the surface of the water. The lower number is one of the nine depth ranges available that best match the depth of the water. As the

4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents PRO 128 Fishfinder Thank YOU Table of Contents Using the Tracker Unit HOW Sonar WorksHOW Sonar Works Feature Memory Simulator OperationSimulator Operation What YOU see ON-SCREEN What You See On-ScreenSurface Clutter Rocky Bottom Soft Bottom Hard Bottom What YOU see on Screen Thermoclines. Thermoclines are sharpControl Functions ID+ adds an additional piece of informaControl Functions Al seconds until a continuous chirp is heard Menu Functions Menu Functions To the userUsing the Tracker Unit Depth Range Right side of the display. Zoom can either operate User controls the location of the Zoom rangeUsing the Tracker Unit Excess of 20 or less than 10 VDC cause the unit to power off Set, and ResetBlack setting when powered off Available OFF and ON. The factory setting isOFF. With this setting, the Tracker unit dis Bottom Black. There are two selectionsRaw Sonar ID+ On Numeral Size settings are remembered when powered off Using the Diagnostic Feature Using the Diagnostic FeatureAdvanced Features MaintenanceMaintenance and Warranty MAINTENANCE/TROUBLESHOOTINGTroubleshooting There is no transducer detected TroubleshootingNothing happens when I turn the unit on There is no bottom reading visible on the displayUnit comes on before I press POWER, and won’t turn off Get gaps in the reading at high speedsTROUBLESHOOTING/WARRANTY My unit loses power at high speedsHumminbird ONE Year Full Warranty Warranty and Service Policy Service PolicyCustomer Support Transducer along with your unit when sending for repairCustomer Support Further information on Humminbird products can be found atRemove and use for Transducer Installation TOPPage Specifications
Top Page Image Contents