Furuno 1943C-BB, GD-1900C-BB Mounting the Processor Unit, Processor unit, mounting dimensions

1.2Mounting the Processor Unit

The unit can be mounted on the deck, a desktop or on a bulkhead. Select a mounting location considering the points below.

•Locate the unit out of direct sunlight.

•Select a location where temperature and humidity are moderate and stable.

•Consider the length of the cable connected among the processor unit, antenna unit (or power supply unit) and control unit.

•For mounting on a bulkhead, be sure the mounting location is strong enough to support the unit (4.1kg) under the pitching and rolling normally encountered on the vessel.

•Leave sufficient space around the unit for maintenance and servicing. Recommended maintenance space appears in the outline drawing at the back of this manual.

•A magnetic compass will be affected if the processor unit is placed too close to the magnetic compass. Observe the following compass safe distances to prevent disturbance to the magnetic compass.

Standard compass: 1.75 m

Steering compass: 1.10 m

Tabletop or deck mounting: Fasten with four tapping screws.

Bulkhead mounting: Mark four fixing hole positions on the bulkhead. Screw in two tapping screws at lower fixing positions, leaving 5 mm protruding. Set the processor unit to the screws and screw in two tapping screws at upper positions. Tighten all screws.

2-φ7 fixing holes

270 250±0.5 235

POWER
1	F.G.	REMOTE FMD DISPLAY
	3	0.3 A MAX
	2
GND

OUTPUT

12VDC

NTSC/PAL

RGB OUT

DJ-1

OPTION

1 2 INPUT NETWORK CONT DATA 3 DATA 2 DATA 1

312-24 VDC

GND

CARD SLOT

7 2 fixing holes

310±0.5

375

Processor unit, mounting dimensions

1-4