Furuno 1823C-BB, GD-1900C-BB, 1953C-BB Network Setup Menu, Network setup menu, Host name window

3.2NETWORK SETUP Menu

Set up the NavNet network to communicate with other NavNet equipment.

1.Open the INSTALL SETUP menu.

2.Press the A: NETWORK SETUP soft key.

IP ADDRESS	172.031.003.007
HOST NAME	RADAR________
RADAR SOURCE	RADAR________
CHART SOURCE*	MCDRIVE-1 ____
	MCDRIVE-2 ____
	______________
SOUNDER SOURCE	SOUNDER_____
AUX SOURCE	WXFAX___
SUBNET MASK	255.255.000.000

GATEWAY ADDRESS 000.000.000.000 OFFSET PORT NUMBER 10000

NETWORK SETUP

A EDIT

E RETURN

Network setup menu

3.Select menu option and press the A: EDIT soft key or [ENTER] knob. For example, select HOST NAME.

HOST NAME

R A D A R _ _ _ _ _ _ _ _

Host name window

4.Use the trackball to select location and press the alphanumeric keys to set character (or value).

5.Press the [ENTER] knob or C: ENTER soft key to finish.

6.Repeat steps 3-5 to enter other items, referring to the table on the next page.

7.Press the [MENU] key to finish.

*: The default setting for card drivers is as follows:

• Slot on the processor unit:	Read only
• Left slot on the CU-200:	Read only
• Right slot on the CU-200:	Read and Write

For the CHART SOURCE setting, the card drive 1 or 2 on the CU-200 can be selected by the soft key "A:1/2." "-1" or "-2" is also displayed for other device (for example, RADAR-1 or PLOTTER-1), but these numbers may be ignored.

3-2