Antenna unit, cover removed
Effective thread length
25 mm
Flat washer
Antenna base plate
Gasket
Radome
5 - 10 mm
Spring | Platform | |
washer | M10 x 25 | |
Apply silicone sealant. | ||
Hex bolt |
How to fasten the radome base to the mounting platform
Wiring and final preparation
4.Drill a hole of approx. 20 mm diameter through the deck or bulkhead to run the signal cable between the antenna unit and the processor unit. (To prevent electrical interference avoid running the signal cable near other electrical equipment and in parallel with power cables.) Pass the cable through the hole. Then, seal the hole with sealing compound for waterproofing.
5.Remove two shield covers in the radome.
6.Remove the cable clamping plate by unfastening four screws and removing a gasket.
| Pan head screws |
| M4x8 4 pcs. |
| Cable clamping plate |
Shield cover | Gasket |
| |
Pan head screws |
|
M4x8 7 pcs. |
|
Shield cover
Pan head screws
M4x8 7 pcs.
Antenna unit, inside view
7.Pass the cable through the hole at the bottom of the radome base.
8.Secure the cable with the cable clamping plate and gasket. Ground the shield wire by