Pioneer DEH-P7100BT DIN Front/Rear-mount, Removing or attaching the trim ring, Leave ample space

Installation

Note

•Check all connections and systems before final installation.

•Do not use unauthorized parts. The use of unauthorized parts may cause malfunctions.

•Consult with your dealer if installation requires drilling of holes or other modifications of the vehicle.

•Do not install this unit where:

—it may interfere with operation of the vehicle.

—it may cause injury to a passenger as a result of a sudden stop.

•The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.

•Optimum performance is obtained when the unit is installed at an angle of less than 60°.

•When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents.

Leave ample space Dashboard

10cm (3-7/8 in.)

10cm (3-7/8 in.)

•The cords must not cover up the area shown in the figure. This is necessary to allow the amplifiers to radiate freely.

Do not cover this area.

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following installation methods.

Removing or attaching the trim ring

1.Extend top and bottom of the trim ring outwards to remove the trim ring.

•When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly.)

•It becomes easy to remove the trim ring if the front panel is released.

Trim ring

10