Pioneer DEH-P7100BT installation manual Contents

Contents
Connecting the units	2
Connecting the power cord	4
When using a subwoofer
without using the optional amplifier	6
When connecting to
separately sold power amp	8
Installation	10
DIN Front/Rear-mount	10
Removing or attaching the trim ring	10
DIN Front-mount	11
DIN Rear mount	11
Fastening the front panel	12
Installing the microphone	12
When installing the microphone
on the sun visor	12
When installing the microphone
on the steering column	13
Adjusting the microphone angle	13
Installing the steering remote control	13
Installing the unit on a left-hand drive car	14

Connecting the units

Note

•When this unit is installed in a vehicle without ACC (accessory) position on the ignition switch, red cable must be wired to the terminal that can detect the operation of the ignition key. Otherwise, battery drain may result.

		CC
	F	A	O			F	O
			N				N
O	F				O	F
			S				S
				T				T
			R	A			R	A
			T				T
ACC position					No ACC position

•Use this unit in other than the following conditions could result in fire or malfunction.

—Vehicles with a 12-volt battery and negative grounding.

—Speakers with 50 W (output value) and 4 ohm to 8 ohm (impedance value).

•To prevent short-circuit, overheating or malfunction, be sure to follow the directions below.

—Disconnect the negative terminal of the battery before installation.

—Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts.

—Place all cables away from moving parts, such as gear shift and seat rails.

—Place all cables away from hot places, such as near the heater outlet.

—Do not pass the yellow cable through a hole into the engine compartment to connect to a battery.

—Cover any disconnected cable connectors with insulating tape.

—Do not shorten any cables.

—Never cut the insulation of the power cable of this unit in order to share the power to other equipment. Current capacity of the cable is limited.

—Use a fuse of the rating prescribed.

—Never wire the speaker negative cable directly to ground.

—Never band together multiple speaker’s

negative cables.

2