Hoshizaki 73180 service manual Shutdown

Page 34

	7. Evaporator	a) Dirty.
		b) Damaged or defective.
	8. Condenser	a) Dirty.

	9. Refrigerant	a) Low charge or overcharged.

		b) Refrigerant lines or components restricted.

	10. Water System	a) Water leaks.
		Shutdown

	1. Bin Control Thermostat Assembly	a) Out of position.
	(with integrated heater)
	NOTICE! Some units contain
	a sticker that states: "The
	bin control heater has been
	disconnected. DO NOT
	disconnected. DO NOT	b) Out of adjustment. See "IV.C. Bin Control Check."
	reconnect the bin control	b) Out of adjustment. See "IV.C. Bin Control Check."
	reconnect the bin control
	heater." In this case, leave
	the bin control heater
	disconnected or replace
	the bin control thermostat
	assembly with 3A2561A03.

34

Image 34

Contents 100BAF-DS 100BAF-AD 100BAF-ADDS Hoshizaki AMERICA, INC Contents Page Important Safety Information Page Specifications 100BAF Auxiliary Codes A-1 and EarlierAuxiliary Codes A-2 and Later 100BAF-DS 100BAF-DS, 2. Auxiliary Codes A-2 and Later 100BAF-AD 100BAF-AD, 2. Auxiliary Codes A-2 and Later 100BAF-ADDS 100BAF-ADDS, 2. Auxiliary Codes A-2 and Later Auxiliary Codes Rear II. General Information ConstructionFront Auxiliary CodesIcemaking Unit Sequence of Operation Freeze CycleFill Cycle Auxiliary Codes A-1 and Earlier Auxiliary Codes A-2 and Later Wiring Diagram Auxiliary Codes A-2 and LaterIcemaker with Optional Drain Pump HS-0248 Performance Data 100BAF SeriesDiagnostic Procedure IV. Service DiagnosisIce Production Check Page Auxiliary Codes A-2 and Later Bin Control Check Float Switch Check Float Switch Cleaning Lower Float white Plastic Retainer ClipOverview Optional Drain Pump HS-0248Drain Pump Check Priming Instructions Float Switch Cleaning Diagnostic Charts No Ice Production Possible Cause StartupShutdown Fill Cycle and Refill Cycle Shutdown Service for Refrigerant Lines Removal and Replacement of ComponentsRefrigerant Recovery Brazing Evacuation and Recharge R-134aImportant Notes for Component Replacement ComponentRemoval and Replacement of Evaporator Assembly Components Upper Bearing Wear Check Removal and Replacement of Extruding Head Removal and Replacement of Auger Removal and Replacement of Evaporator Page 5b. Lower Housing Page VI. Maintenance Maintenance Schedule Frequency Area TaskCleaning and Sanitizing Instructions Cleaning SolutionPage Sanitizing Solution Page Cleaning Solution Page Sanitizing Solution Storage Bin Drain Condenser VII. Preparing the Icemaker for Periods of Non-Use Auxiliary Codes A-1 and Earlier Skip to stepVIII. Disposal