Kawai CN31 manual Press the PLAY/STOP button to fi nish recording

Page 33

Page

33

…Step2

Start to play the piano.

While recording the second part, the previously recorded first part will also play. During this time, the LED indicators for the REC button and PLAY/STOP button will be turned on.

To start playing back the fi rst part and then recording the second part from a certain point, later in the song, press the PLAY/STOP button instead of playing the keyboard to start playback, then begin recording the second part when necessary.

…Step3

Press the PLAY/STOP button to fi nish recording.

The LED indicators for the PLAY/STOP button and the REC button will turn off and the newly recorded part will be saved to memory automatically.

„The total recording capacity of the CN piano’s memory is approximately 15,000 notes, with button and pedal presses also counted as one note.

When the maximum capacity is reached, recording will stop and all music recorded up until that point will be saved to memory automatically.

„Performance data stored inside the CN piano’s memory will be saved even after turning off the power.

„It is possible to temporarily turn off (mute) a previously recorded part, for example PART1, before recording a new part, for example PART2. This function can be useful to avoid distraction while recording. To mute PART1, hold the PLAY/STOP button and press the PART1 button, the LED indicator for PART1 will turn off.

„Panel operations stored during recording: x Changes made to the sound type.

xShifts between DUAL and SPLIT modes.

„Panel operations NOT stored during recording:

xChanges made to effect settings – the selected effect will be applied to the selected sound type.

xChanges made to tempo.

xChanges made using the BALANCE slider in DUAL or SPLIT modes – the volume balance set immediately before recording will be stored, however.

xTurning the TOUCH CURVE or TRANSPOSE functions ON or OFF – regardless of the transpose settings the performance will be replayed at the pitch originally used for the recording.

RECORDER

4

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Piano Playing Function Lesson Page Table of Contents Important Safety Instructions Conforms to the specified power voltage If you are going to use an AC power cordFailure to do so may result in fire Doing so may cause electric shockProduct is handled incorrectly Failure to do so may cause breakdown of thisProduct and other devices Instruction for AC power cord U.K ‘ Pedals ‘ Front Panel‘ Headphones Adjust the volume level using the Master Volume slider Press the Power Switch to turn on the power‘ Setting UP the Piano Basic Operations‘ Demo Songs Press the Concert Magic and Lesson buttons simultaneously‘ Selecting a Preset Sound „ Preset SoundsPlay the keyboard Two different sounds will be heard at the same time Step DualPress the Split button SplitLED indicator for the Split button will turn off Press the Split button to exit the split mode‘ Entering ‘FOUR HANDS’ Mode ‘FOUR HANDS’ Mode‘ Exiting ‘FOUR HANDS’ Mode To exit ‘Four Hands’ Mode, press the Split button againPress the Reverb button EFFECTS/REVERB‘ Adding Reverb ¡ Reverb‘ Adding Other Effects Press the Effects buttonSelecting the Touch Sensitivity Transposing the Piano To listen, press the Play Stop button Playing with Concert Magic‘ Selecting a Song ‘ Listening to the Song‘ Performing a Song ‘ Concert Magic Part Volume Balance„ Easy Beat ‘ Concert Magic Song Arrangement Types„ Melody Play „ SkillfulStart by tapping any key with a constant steady beat Press and hold the Concert Magic button‘ Steady Beat ‘ Concert Magic Demo ModesTempo value will be shown in the display ‘ Concert Magic Playback SpeedPress the Tempo button MetronomePress the Tempo button again to stop the metronome Press the Beat buttonVolume level of the metronome can also be adjusted ‘ Adjusting the Metronome VolumePress the Beat button again to stop the metronome Press the Tempo and Beat buttons simultaneouslyPress the Lesson button Selecting a BOOK/SONGListening to and Playing a Song ‘ Adjusting the Tempo of a SongPress the PLAY/STOP button to play the selected song ‘ Exiting the Lesson FunctionPress the REC button while the Lesson button is lit Recording a Song PracticePress the PLAY/STOP button to listen to the recording ‘ Playing Back the RecordingIf no Part is selected PART1 will be selected automatically Recording REC ButtonStart to play the piano Press the PLAY/STOP button to stop recording‘ Recording a Second Part Press the PLAY/STOP button to fi nish recording ‘ Playing Back Recorded Parts Separately Playing Back a SongLED indicator of the selected song will start to fl ash LED indicators will display which songs have been recordedErasing a Song Hold down the REC and PLAY/STOP buttons‘ Exiting a Function Mode ‘ Entering a Function ModeUse the Value buttons to raise or lower the pitch TuningBrief Explanation of Temperaments Temperament‘ KEY Signature of Temperament Use the Value buttons to change the type of temperament‘ Midi Overview Midi Channel Use the Value buttons to change the channel numberChannel number can be set from 1 to Transmit Program Change ON/OFF Offon Use the Value buttons to toggle local control on and off Local Control ON/OFFMULTI-TIMBRAL Mode ON/OFF Use the Value buttons to toggle channel mute on and off Channel MuteUse the Value buttons to change the program change number Sending Program Change NumbersLower Octave Shift can be set from 0 to Lower Octave ShiftUse the Value buttons to toggle lower pedal on and off Lower Pedal ON/OFF‘ Connecting to Other Devices ‘ Assembly Instructions „ Assembly Sequence„ Parts Provided 7 y ‘ Specifications 10 F7 ‘ Midi Exclusive Data FormatFunction Transmit Receive Remarks ‘ Midi Implementation ChartPage Page OW1004E-S0701
Top Page Image Contents