Kawai CN31 manual ‘ Assembly Instructions, „ Parts Provided, „ Assembly Sequence

Page

51

‘ASSEMBLY INSTRUCTIONS

Caution y Ensure that this instruction manual is read thoroughly before attempting to assemble the CN piano, and that two or more people work on assembly.

yIt may be necessary to tilt the unit by 90 degrees while assembling the CN piano. During this time, ensure that hands are not caught in the piano, keyboard lid, or score stand, and that the piano is not dropped on an individual’s feet.

„PARTS PROVIDED

Before attempting to assemble the CN piano unit, ensure that all parts are included. A Phillips-head screwdriver will also be required to assemble the unit (not included).

(A) Piano (x 1)

(B) Pedal board (x 1)

(C) End panel (x 1 each for left and right)	(E)	(F)	(G)	(H)	(I)	(J)	(K)
	Adjuster bolt	φ 4 x 16	φ 4 x20	φ 4 x30	M6 x 25	Cord clamp	Headphone hook and screws
(D) Back panel (x 1)
(E) Adjuster bolt (x 1)
(F) Screw:φ 4 x 16 (x 4)
(G) Screw:φ 4 x 20 (x 4)
(H) Screw:φ 4 x 30 (x 2)							Screw
							(x 2)
(I) Screw: M6 x 25 (x 4)

(J)Cord clamp (x 2)

(K)Headphone hook and screws (x 1 set)

(L)Power cord (x 1)

„ASSEMBLY SEQUENCE

Caution y Be careful not to scratch or damage the floor, piano, or stand at the time of assembly.

1.Screw the adjuster bolt (E) into the threaded screw hole provided on the pedal.

2.From the side of the screw that is already on the backside of the pedal board (B), slide and insert the bracket of the end panel (C).

3.While pressing the end panel (C) against the pedal board (B), tighten the already-provided screws, one each on the left and right sides, and then tighten two screws (F) on each side.

4.Untie and pull out the pedal cable.

5.Set the back panel (D) and tighten the screws (G) (H) into the prepared holes. Loosely tighten the screws with the * symbol.

1

(E)

2 y 3

Already-provided screw (F)

(F)

(C)

(B)

APPENDICES

6

4 y 5

(H)* (D) (H)*

(G) (G) (G)

(Untie this twist tie from the cable)