Kawai CN31 manual Connecting to Other Devices

Page 50

Page

50

6. APPENDICES

CONNECTING TO OTHER DEVICES

Caution y Do not directly connect the LINE IN and LINE OUT jacks of the CN31 together with a cable. An audio loop (oscillation sound) will occur, resulting in damage to the unit.

1	2	3	4	5
	/

6	APPENDICES

Pedal cable

Headphones

Ampliﬁers, Speakers, or similar
equipment	External MIDI devices
Audio equipment or	External MIDI devices
electronic instruments

1 LINE OUT JACKS

These jacks provide stereo output of the CN31 piano’s sound to ampliﬁ ers, tape recorders or similar equipment. The audio signal coming through the LINE IN jacks is also routed to these jacks. The CN31 piano’s sound is mixed with the LINE IN signals.

The CN31 piano’s VOLUME slider controls the output level of its own sound without affecting the level of the LINE IN signal.

2 LINE IN JACKS

These jacks are used to connect a pair of stereo outputs from other audio equipment or electronic instruments to the CN31 piano’s speakers. The audio signal coming through these jacks bypasses the CN31 piano’s volume control. To adjust the volume level, use the output control of the external device.

3 MIDI JACKS

These jacks are used to connect external MIDI devices with the CN piano. There are two terminals: MIDI IN and

MIDI OUT.

4 PEDAL JACK

Connect the pedal cord from the pedal board to this jack.

5 HEADPHONE JACKS

There are two headphone jacks located on the left underside of the piano.

The piano's sound and any audio signal that is connected to the LINE IN jacks will be heard through the headphones.

Image 50

Contents Piano Playing Function Lesson Page Table of Contents Important Safety Instructions Failure to do so may result in fire If you are going to use an AC power cordConforms to the specified power voltage Doing so may cause electric shockProduct and other devices Product is handled incorrectlyFailure to do so may cause breakdown of this Instruction for AC power cord U.K ‘ Front Panel ‘ Pedals‘ Headphones ‘ Setting UP the Piano Press the Power Switch to turn on the powerAdjust the volume level using the Master Volume slider Basic OperationsPress the Concert Magic and Lesson buttons simultaneously ‘ Demo SongsPlay the keyboard ‘ Selecting a Preset Sound„ Preset Sounds Dual Two different sounds will be heard at the same time StepSplit Press the Split buttonPress the Split button to exit the split mode LED indicator for the Split button will turn off‘ Exiting ‘FOUR HANDS’ Mode ‘FOUR HANDS’ Mode‘ Entering ‘FOUR HANDS’ Mode To exit ‘Four Hands’ Mode, press the Split button again‘ Adding Reverb EFFECTS/REVERBPress the Reverb button ¡ ReverbPress the Effects button ‘ Adding Other EffectsSelecting the Touch Sensitivity Transposing the Piano ‘ Selecting a Song Playing with Concert MagicTo listen, press the Play Stop button ‘ Listening to the Song‘ Concert Magic Part Volume Balance ‘ Performing a Song„ Melody Play ‘ Concert Magic Song Arrangement Types„ Easy Beat „ Skillful‘ Steady Beat Press and hold the Concert Magic buttonStart by tapping any key with a constant steady beat ‘ Concert Magic Demo Modes‘ Concert Magic Playback Speed Tempo value will be shown in the displayPress the Tempo button again to stop the metronome MetronomePress the Tempo button Press the Beat buttonPress the Beat button again to stop the metronome ‘ Adjusting the Metronome VolumeVolume level of the metronome can also be adjusted Press the Tempo and Beat buttons simultaneouslySelecting a BOOK/SONG Press the Lesson buttonPress the PLAY/STOP button to play the selected song ‘ Adjusting the Tempo of a SongListening to and Playing a Song ‘ Exiting the Lesson FunctionPress the PLAY/STOP button to listen to the recording Recording a Song PracticePress the REC button while the Lesson button is lit ‘ Playing Back the RecordingRecording REC Button If no Part is selected PART1 will be selected automatically‘ Recording a Second Part Start to play the pianoPress the PLAY/STOP button to stop recording Press the PLAY/STOP button to ﬁ nish recording Playing Back a Song ‘ Playing Back Recorded Parts SeparatelyErasing a Song LED indicators will display which songs have been recordedLED indicator of the selected song will start to ﬂ ash Hold down the REC and PLAY/STOP buttons‘ Entering a Function Mode ‘ Exiting a Function ModeTuning Use the Value buttons to raise or lower the pitchTemperament Brief Explanation of TemperamentsUse the Value buttons to change the type of temperament ‘ KEY Signature of Temperament‘ Midi Overview Channel number can be set from 1 to Midi ChannelUse the Value buttons to change the channel number Transmit Program Change ON/OFF Offon Local Control ON/OFF Use the Value buttons to toggle local control on and offMULTI-TIMBRAL Mode ON/OFF Channel Mute Use the Value buttons to toggle channel mute on and offSending Program Change Numbers Use the Value buttons to change the program change numberLower Octave Shift Lower Octave Shift can be set from 0 toLower Pedal ON/OFF Use the Value buttons to toggle lower pedal on and off‘ Connecting to Other Devices „ Parts Provided ‘ Assembly Instructions„ Assembly Sequence 7 y ‘ Specifications ‘ Midi Exclusive Data Format 10 F7‘ Midi Implementation Chart Function Transmit Receive RemarksPage Page OW1004E-S0701