Pioneer XRE3138-A manual Speaker terminals, Hints on speaker placement, Speaker placement diagrams

Page 15

Connecting up

03

Speaker terminals

Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any of the bare speaker wire is touching the back panel when you switch the unit on, the power may cut off as a safety measure. Use good quality speaker wire to connect the speakers to the receiver.

Caution

These speaker terminals are hazardous when live. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord.

Hints on speaker placement

Speakers are usually designed with a particular placement in mind. Some are designed to be floorstanding, while others should be placed on stands to sound their best. Some should be placed near a wall; others should be placed away from walls. We have provided a few tips on getting the best sound from your speakers (following), but you should also follow the guidelines on placement that the speaker manufacturer provided with your particular speakers to get the most out of them.

Place the front left and right speakers at equal distances from the TV.

When placing speakers near the TV, we recommend using magnetically shielded speakers to prevent possible interference, such as discoloration of the picture when the TV is switched on. If you do not have magnetically shielded speakers and notice discoloration of the TV picture, move the speakers farther away from the TV.

Place the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen.

If possible, place the surround speakers slightly above ear level.

Try not to place the surround speakers further away from the listening position than the front and center speakers. Doing so can weaken the surround sound effect.

To achieve the best possible surround sound, install your speakers as shown below. Be sure all speakers are installed securely to prevent accidents and improve sound quality.

Caution

If you choose to install the center speaker on top of the TV, be sure to secure it with putty, or by other suitable means, to reduce the risk of damage or injury resulting from the speaker falling from the TV in the event of external shocks such as earthquakes.

Make sure no exposed speaker wire is touching the rear panel, this may cause the receiver to turn off automatically.

Speaker placement diagrams

The following illustrations show 5.1 channel speaker setups.

3-D view of 5.1 channel speaker setup

Overhead view of speaker setup

 

 

Front

 

 

 

 

 

Front

 

 

left

Center

 

 

right

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Subwoofer

Surround

 

 

 

 

 

 

Surround

 

left

 

 

 

 

 

 

right

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Listening position

English Deutsch Français Italiano Nederlands Español

15

En

Image 15
Contents VSX-517 Federal Communications Commission Declaration of Conformity Risk of Electric Shock Do not Open Contents Checking what’s in the box Installing the receiverBefore you start Before you start ChapterListening to Surround Sound Minute guide02 5 minute guide Chapter Introduction to home theaterMinute guide Using the Quick Setup Connecting up Connecting up ChapterMaking cable connections Connecting up Connecting a TV and DVD player English DeutschFrançais Italiano If your set-top box has a digital output Connecting upConnecting the multichannel analog OutputsCD-R, MD, DAT, Tape recorder, etc Connecting up Connecting other audio componentsAbout the WMA9 Pro decoder English Deutsch Français Italiano Nederlands EspañolConnecting other video components Using the component video jacksDVR, VCR, LD player, etc To improve AM reception Connecting antennasUsing external antennas To improve FM receptionConnecting up Connecting the speakers Banana plugsTighten terminal Speaker terminals Hints on speaker placementSpeaker placement diagrams Following illustrations show 5.1 channel speaker setupsControls and displays Controls and displays ChapterFront panel Español Controls and displaysDisplay English Deutsch Français Italiano NederlandsPRO Logic DigitalDTS AnalogEnglish Deutsch Français Controls and displays Remote controlMenu PhaseDVD/DVR ReceiverMPX Auto playback Listening to your systemListening to your system Chapter Listening in surround soundUsing the Advanced surround effects Setting the effect optionsListening to your system Using Front Stage Surround Advance Using Stream DirectListening to your system Listening in stereo Using Virtual Surround Back VSB Listening to your system Choosing the input signalEnhancing dialog Listening to your system Using Phase ControlUsing Midnight and Loudness Using the tone controlsListening to your system Using the Sound Retriever Playing other sourcesSelecting the multichannel analog inputs Manual speaker setup System Setup menuSystem Setup menu Chapter Using the System Setup menuChannel level System Setup menuDefault setting 100Hz Crossover networkAssigning the component video inputs Input Assign menuSpeaker Distance Assigning the digital inputsDynamic Range Control Setup Other setup menuDual Mono Setup LFE Attenuator SetupListening to the radio Using the tunerUsing the tuner Chapter Saving station presetsEnglish Making recordingsMaking recordings Chapter Making an audio or a video recordingTroubleshooting Additional informationAdditional information Chapter Resetting the main unit Additional informationLfeatt Amplifier section SpecificationsPower cord caution Switching the speaker impedanceCleaning the unit To establish a safe level We Want You Listening For a LifetimeAdditional information Laboratories Table des matières Pour faire un enregistrement Information complémentaireFaire un enregistrement audio ou vidéo Chapitre Portée de la télécommandeInstallation du récepteur PréparatifsEcoute en son surround Lancez la lecture d’un DVD et réglez le volumeGuide en 5 minutes Présentation de l’appareil de cinéma à domicileAppuyez sur Enter pour confirmer votre configuration Utilisation de la touche de réglage rapide Quick SetupCâbles vidéo RaccordementsRaccordements des câbles Câbles audio numériquesVideo Raccordement d’un téléviseur et d’un lecteur de DVDSAT Audio et Video du récepteur.2 Décodeur numériqueRaccordement d’un récepteur satellite ou d’un boîtier Raccordement des sorties analogiques multicanauxRaccordement d’autres appareils audio Propos du décodeur WMA9 ProCD-R, MD, DAT, magnétoscope, etc Raccordement d’autres appareils vidéo Utilisation des prises femelles vidéo en composantesVCR, DVR, Lecteur LD, etc Raccordement des antennes DeutschPour améliorer la réception AM Refermez la borne Raccordement des enceintesConseils d’installation des enceintes Bornes d’enceinteSchéma de disposition des enceintes Panneau frontal Commandes et affichagesPrise Phones Commandes du menu de configuration du systèmeIndicateurs Signal Select AffichageNiveau du volume principal Indicateurs du Syntoniseur MonoIndicateur d’enceinte Télécommande Permet de confirmer et de quitter l’écran du menu affiché Commandes du TunerSleep Dimmer Touches Input SelectorEnglish Deutsch Français Italiano Nederlands Español Lecture en mode Auto Écoute de sources à l’aide de votre systèmeÉcoute d’une source en son surround Utilisation des effets surround avancés Réglage des options d’effetItaliano Écoute en mode stéréo Utilisation des modes Stream DirectUtilisation de la fonction Front Stage Surround Advance Choix du signal d’entrée Utilisation de l’effet surround arrière virtuel VSBVSB OFF Midnight et Loudness Utilisation de la fonction Phase ControlMode Dialog enhancement Utilisation des commandes de tonalitéUtilisez les touches de sélection d’entrée Utilisation de la fonction Sound RetrieverLecture d’autres sources Sélection des entrées analogiques multicanauxRéglage des enceintes Menu de configuration du systèmeUtilisation du menu de configuration du système Réglage manuel des enceintesDeutsch Français Italiano Nederlands Español SP SetupRéseau de recouvrement Niveau des canauxAffectation des entrées de l’appareil vidéo Menu d’affectation d’entréeDistance des enceintes Affectation des entrées numériquesRéglage mono double Menu de configuration OtherConfiguration du contrôle de la plage dynamique Sélectionnez Other à partir du menu System SetupPour nommer les stations préréglées Utilisation du tunerPour écouter la radio Mémorisation de stations prérégléesFaire un enregistrement audio ou vidéo Pour faire un enregistrementGuide de dépannage Information complémentaireYES ou Plus La fonction Phase ControlAppuyez sur Setup pour confirmer Réinitialisation de l’appareil principalSection amplificateur Permutation de l’impédance des enceintesSpécifications Précautions d’usage pour le cordon d’alimentationNettoyage de l’appareil Limited Warranty Garantie Limitée Pioneer Corporation