Pioneer XRE3138-A manual Listening to your system Choosing the input signal

Listening to your system

Choosing the input signal

• Default setting: AUTO

You need to hook up a component to both analog and digital inputs on the rear of the receiver to select between input signals.1

•Press SIGNAL SELECT (front panel) to select the input signal corresponding to the source component.

Each press cycles through the following:

•AUTO – This automatically switches to DIGITAL if a digital source is detected, otherwise it remains on ANALOG.

•ANALOG – Selects the analog inputs.

•DIGITAL – Selects the digital input.

When set to DIGITAL or AUTO, 2 DIGITAL lights when a Dolby Digital signal is input, and DTS lights when a DTS signal is input.

Using Virtual Surround Back (VSB)

Selecting this mode allows you to hear a virtual surround back channel through your surround speakers. For example, you can choose to listen to sources with no surround back channel information (for example, 5.1 encoded material) with emulated 6.1 encoding (VSB ON). Sometimes the material may sound better in the 5.1 format for which it was originally encoded. In this case you can simply switch it off (VSB OFF).2

Depending on the input signal and the Listening Mode, the Virtual Surround Back mode may not be effective.

PHASE

CONTROL

PHASE	DIALOGUE AUTO SURR/	DVD/LD	DVD 5.1	TV/SAT	DVR/VCR	CD	CD-R/TAPE/MD	FM
CONTROL	ENHANCEMENT DIRECT
	SOUND	MIDNIGHT/	VSB
	RETRIEVER LOUDNESS		MODE	TONE

STANDBY/ON

PHONES	SIGNAL	TUNER	QUICK
	SELECT DIMMER	EDIT	SETUP	SETUP RETURN

MULTI JOG

•Press VSB MODE (front panel) to select a virtual surround back channel option. Each press cycles through the options as follows:

•VSB ON – Virtual Surround Back is always used (for example, on 5.1 encoded material)

•VSB OFF – Virtual Surround Back mode is switched off

05

English Deutsch Français Italiano Nederlands Español

Note

1• This receiver can only playback Dolby Digital, PCM (32 kHz to 96 kHz), DTS and WMA9 Pro digital signal formats. With other digital signal formats, set to ANALOG.

•You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make the proper digital connections (page 9) and set the signal input to DIGITAL.

•Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player. 2 The Virtual Surround Back mode is not effective when using headphones, Stream Direct, Stereo, Front Stage Surround Advance mode. It is also unavailable if the surround speaker is set to NO in Speaker setting on page 28.

25

En