Pioneer XRE3138-A manual Input Assign menu, Speaker Distance, Assigning the digital inputs

06The System Setup menu

Speaker Distance

For good sound depth and separation from your system, you need to specify the distance of your speakers from the listening position. The receiver can then add the proper delay needed for effective surround sound.

1Select ‘SP DISTN.’ from the SP SETUP menu.

2Use / to choose the speaker that you

want then set the distance.

Use / to adjust the distance of each speaker (in 0.5 ft. (15 cm) increments).

2Use / to select the number of the

digital input to which you’ve connected your digital component.

The numbers correspond with the numbers beside the inputs on the back of the receiver.

3Select the component that corresponds with the one you connected to that input.

•Use the / buttons and ENTER to select DVD, TV, CD, CDR, DVR or OFF.

•If you assign a digital input to a certain function (for example, DVD) then any digital inputs previously assigned to that function will automatically be switched off.

The Input Assign menu

You only need to make settings in the Input Assign menu if you didn’t hook up your digital equipment according to the default settings for the digital inputs, or if you have connected equipment using component video cables.

1Select ‘IN ASSIG.’ from the System Setup menu.

2Use / to select the setting you want to adjust then press ENTER.

•DIG. IN – See Assigning the digital inputs below.

•COMP. IN – See Assigning the component video inputs below.

3Press RETURN after making the adjustments necessary for each setting.

Assigning the digital inputs

• Default settings:

COAX 1 (coaxial) – DVD

COAX 2 (coaxial) – DVR

OPT 1 (optical) – CD

You only need to do this if you didn’t connect your digital components according to the defaults above. This tells the receiver what component is connected to which terminal so it corresponds to the buttons on the remote.

1 Select DIG. IN from the IN ASSIG. menu.

30

Assigning the component video inputs

• Default settings:

COMP 1 – DVD

COMP 2 – TV

COMP 3 – DVR

If you didn’t make component video connections according to the defaults above, you must assign the numbered input to the component you’ve connected (or else you may see the video signal of a different component). For more on this, see Using the component video jacks on page 12.

1Select COMP. IN from the IN ASSIG. menu.

2Use / to select the number of the component video input to which you’ve connected your video component.

The numbers match the numbers beside the inputs on the back of the receiver.

3Select the component that corresponds with the one you connected to that input.

•Use the / buttons and ENTER to select DVD, TV, DVR or OFF.

•Make sure you have connected the audio from the component to the corresponding inputs on the rear of the receiver.

En