Pioneer XRE3138-A manual Connecting up Chapter, Making cable connections

03Connecting up

Chapter 3:

Connecting up

Making cable connections

Make sure not to bend the cables over the top of this unit (as shown in the illustration). If this happens, the magnetic field produced by the transformers in this unit may cause a humming noise from the speakers.

Important

•Before making or changing any connections, switch off the power and disconnect the power cord from the AC outlet.

•Before unplugging the power cord, switch the power into standby.

Digital audio cables

Commercially available coaxial digital audio cables or optical cables should be used to

connect digital components to this receiver.1

Coaxial digital audio cable Optical cable

Video cables

Standard RCA video cables

These cables are the most common type of video connection and should be used to connect to the composite video terminals. They have yellow plugs to distinguish them from cables for audio.

Standard RCA video cable

Analog audio cables

Use stereo RCA phono cables to connect analog audio components. These cables are typically red and white, and you should connect the red plugs to R (right) terminals and white plugs to L (left) terminals.

Component video cables

Use component video cables to get the best possible color reproduction of your video source. The color signal of the TV is divided into the luminance (Y) signal and the color (PB and PR) signals and then output. In this way, interference between the signals is avoided.

Analog audio cables	Component video cables
Right (red)	Green (Y)
Left (white)	Blue (PB)
	Red (PR)

Note

1• When connecting optical cables, be careful when inserting the plug not to damage the shutter protecting the optical socket.

•When storing optical cable, coil loosely. The cable may be damaged if bent around sharp corners.

•You can also use a standard RCA video cable for coaxial digital connections.

8

En