Nordyne RC 92+ Clearances to Combustible Materials, Minimum Clearances to Combustible Material

Model	Furnace		Dimensions (inches)			Shipping
						Weight
Number	Btuh
		A	B	C	D	(lbs)
*RC040	40,000	14 1/4	12 3/4	5 1/8	11 3/4	133
*RC060	60,000	14 1/4	12 3/4	5 1/8	11 3/4	140
*RC080	80,000	19 3/4	18 1/4	7 7/8	17 1/4	172
*RC100	100,000	19 3/4	18 1/4	7 7/8	17 1/4	180
*RC120	120,000	22 1/2	21	9 1/4	20	204
*RL040	40,000	14 1/4	12 3/4	4 5/8	12 3/4	135
*RL060	60,000	14 1/4	12 3/4	4 5/8	12 3/4	135
*RL080	80,000	19 3/4	18 1/4	10	18 1/4	174
*RL100	100,000	19 3/4	18 1/4	10	18 1/4	185
*RL120	120,000	22 1/2	21	12 1/2	21 1/8	209

Table 3. Furnace Dimensions and Shipping Weights

CLEARANCES TO COMBUSTIBLE MATERIALS

This furnace is Designed Certified by CSA International for the minimum clearances to combus- tible material listed in Table 4. See the furnace name plate, located inside the furnace cabinet, for specific model number and clearance information.

MINIMUM CLEARANCES TO COMBUSTIBLE MATERIAL

Furnace	Cabinet		Minimum Clearances (Inches)
Input	Width
(Btuh)	(Inches)	Side	Vent	Back	Top	Front
40,000	14 1/4	0	0	0	1	1*
60,000	14 1/4	0	0	0	1	1*
80,000	14 1/4	0	0	0	1	1*
100,000	19 3/4	0	0	0	1	1*
120,000	22 1/2	0	0	0	1	1*

* When installed horizontally, 24 inches is required for servicing.

Table 4. Minimum Clearances to Combustible Materials

services both the appliance and the carbon monoxide detector;

b. Have battery back-up power;

c. Meet ANSI/UL 2034 Standards and comply with NFPA 720 (2005 Edition);and

d. Have been approved and listed by a Nationally Recognized Testing Laboratory as recognized under 527 CMR.

3.A Product-approved vent terminal must be used, and if applicable, a Product- approved air intake must be used. In-

stallation shall be in strict compliance with the manufacturer’s instructions. A copy of the installation instructions shall remain with the appliance or equipment at the completion of the installation.

4.A metal or plastic identification plate shall be mounted at the exterior of the building, four feet directly above the lo- cation of vent terminal. The plate shall be of sufficient size to be easily read from a distance of eight feet away, and read “Gas Vent Directly Below”.

9