SoundCraft 1601E manual Front Panel, EQ CUT -Rotary

Page 19

FRONT PANEL

1.CH1: 3 Position curve control and Reverse

These controls allow you to change the curve of the input fader and reverse the fader action. See also page 23.

2.X-FADER:Rotary position curve control and Reverse

These controls allow you to change the curve of the x-fader and reverse the fader action. See also page 27.

3.CH2: 3 Position curve control and Reverse

These controls allow you to change the curve of the input fader and reverse the fader action. See also page 23.

4.LEVEL -Rotary control

This control sets the audio level to the connected headphones. See also page 28.

5.HEADPHONE OUT -Jack connectors

Connect the 1/4” or mini jack plug from your headphones to the appropriate connector.

6.SELECT Toggle switch

This switch allows you to select MASTER or CUE monitoring. See also page 28.

7.EQ CUT -Rotary

This control can be used to change the CUE monitor EQ. To the right, high frequencies are cut and to the left, low frequencies are cut. See also page 28.

19

Image 19
Contents Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow Recommended Headphone Impedance = 200 Ohms Safety Symbol GuideHeadphones Safety Warning TIPBPM Effects IntroductionPage General Precautions InstallationMains Installation Audio Wiring Initial Wiring ConsiderationsShielding Working Safely with Sound Points to RememberEnvironmental Considerations Inspection and InstallationPowering Unpacking and InspectionConnecting to a Typical Sound System Replacing The Faders Making Adjustments and Fitting SparesSetting The Pre-trim Pads Changing The Orientation Of The Phono/Line SwitchesPage TOP Panel DescriptionBPM FX MIX Fader BPM FX Section seeBalanced Master Outputs -XLR Connectors Rear Connector PanelBalanced Booth Outputs -XLR Connectors EQ CUT -Rotary Front PanelMIC / Line Input Combi -XLR ConnectorOperation Getting StartedMIC Insert Socket rearcon Level ControlEQ -LOW Control EQ -HIGH ControlClip Indicators Input Selector SwitchesPRE-TRIM Pads MID EQ Channel Volume FadersTrim HI EQSend -SELECT FX Send & Return / AUXSend -LEVEL Record OUTReturn / AUX -LEVEL Clip IndicatorFX ON/OFF Switch FX SEND/RETURN RE-CONFIGURATIONMaster / Booth Output Exciter FaderFader Curve Headphone Sockets Headphone MonitorLevel MASTER/CUE SelectMonitor Operating Criteria Bank ModeBeats Indicator BPM FX ModuleIsolator TAP/CLEARY Controls BPM FX MIX ON-OFF switchesActivating the Effects Setting UPQuick Start ConnectionsTAP -Tempo Edit OperationBPM Range TAP/CLEAR ButtonApplying the BPM-FX Effect Start SyncMIX Fader Effect ControlsRotary Encoder Band Isolator Mode Bank select SINGLE/MULTI Mode OperationSingle Mode Additional speed settings for FILTER/FLANGER/PANNER Multi ModeProgram Edit and Recall Filter EffectsFrequency SUB-MENU Speed DelayRepeats Y SPS PANWAY Split Y Depth X mark space ratio CutterSlope Y Resonance is factory set @ 75% FlangeDepth Y Hints & Tips PRE-SET Voice ListBlock Diagram Connecting Leads Troubleshooting Specifications Warranty Post after the channel fader GlossaryEqualising the system to notch out the offending frequencies Riaa