SoundCraft 1601E manual Potters BAR

Page 2

IMPORTANT

Please read this manual carefully before using

your mixer for the first time.

© Harman International Industries Ltd. 2005

All rights reserved

Parts of the design of this product may be protected by worldwide patents.

Part No. ZM0330-01

Soundcraft is a trading division of Harman International Industries Ltd. Information in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. Soundcraft shall not be liable for any loss or damage whatsoever arising from the use of information or any error contained in this manual.

No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, electrical, mechanical, optical, chemical, including photocopying and recording, for any purpose without the express written permission of Soundcraft.

Harman International Industries Limited

Cranborne House

Cranborne Road

POTTERS BAR

Hertfordshire

EN6 3JN

UK

Tel: +44 (0)1707 665000

Fax: +44 (0)1707 660742

http://www.ureidj.com

2

Image 2
Contents Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow TIP Safety Symbol GuideHeadphones Safety Warning Recommended Headphone Impedance = 200 OhmsIntroduction BPM EffectsPage Mains Installation InstallationGeneral Precautions Shielding Initial Wiring ConsiderationsAudio Wiring Points to Remember Working Safely with SoundUnpacking and Inspection Inspection and InstallationPowering Environmental ConsiderationsConnecting to a Typical Sound System Changing The Orientation Of The Phono/Line Switches Making Adjustments and Fitting SparesSetting The Pre-trim Pads Replacing The FadersPage Description TOP PanelBPM FX Section see BPM FX MIX FaderBalanced Booth Outputs -XLR Connectors Rear Connector PanelBalanced Master Outputs -XLR Connectors Front Panel EQ CUT -RotaryGetting Started Combi -XLR ConnectorOperation MIC / Line InputEQ -HIGH Control Level ControlEQ -LOW Control MIC Insert Socket rearconPRE-TRIM Pads Input Selector SwitchesClip Indicators HI EQ Channel Volume FadersTrim MID EQRecord OUT FX Send & Return / AUXSend -LEVEL Send -SELECTFX SEND/RETURN RE-CONFIGURATION Clip IndicatorFX ON/OFF Switch Return / AUX -LEVELMaster / Booth Output Fader Curve FaderExciter MASTER/CUE Select Headphone MonitorLevel Headphone SocketsMonitor BPM FX Module Bank ModeBeats Indicator Operating CriteriaY Controls TAP/CLEARIsolator ON-OFF switches BPM FX MIXConnections Setting UPQuick Start Activating the EffectsTAP/CLEAR Button OperationBPM Range TAP -Tempo EditEffect Start Sync Applying the BPM-FXRotary Encoder Effect ControlsMIX Fader Band Isolator Single Mode SINGLE/MULTI Mode OperationMode Bank select Program Edit and Recall Multi ModeAdditional speed settings for FILTER/FLANGER/PANNER Frequency EffectsFilter SUB-MENU Repeats Y DelaySpeed WAY Split Y PANSPS Slope Y CutterDepth X mark space ratio Depth Y FlangeResonance is factory set @ 75% PRE-SET Voice List Hints & TipsBlock Diagram Connecting Leads Troubleshooting Specifications Warranty Glossary Post after the channel faderEqualising the system to notch out the offending frequencies Riaa