SoundCraft 1601E manual Safety Symbol Guide, Headphones Safety Warning, Tip

Page 6

For your own safety and to avoid invalidation of the

warranty please read this section carefully.

SAFETY SYMBOL GUIDE

For your own safety and to avoid invalidation of the warranty all text marked with these symbols should be read carefully.

WARNINGS

The lightning flash with arrowhead symbol, is intended to alert the user to the presence of un- insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

CAUTIONS

The exclamation point within an equilateral triangle

is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

NOTES

Contain important information and useful tips on

the operation of your equipment.

HEADPHONES SAFETY WARNING

Contain important information and useful tips on

headphone outputs and monitoring levels.

Recommended Headphone Impedance >= 200 Ohms.

TIP

Contains a useful “tip” on how to get the best out

of your equipment.

6

Image 6
Contents Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow TIP Safety Symbol GuideHeadphones Safety Warning Recommended Headphone Impedance = 200 OhmsIntroduction BPM EffectsPage Installation General PrecautionsMains Installation Initial Wiring Considerations Audio WiringShielding Points to Remember Working Safely with SoundUnpacking and Inspection Inspection and InstallationPowering Environmental ConsiderationsConnecting to a Typical Sound System Changing The Orientation Of The Phono/Line Switches Making Adjustments and Fitting SparesSetting The Pre-trim Pads Replacing The FadersPage Description TOP PanelBPM FX Section see BPM FX MIX FaderRear Connector Panel Balanced Master Outputs -XLR ConnectorsBalanced Booth Outputs -XLR Connectors Front Panel EQ CUT -RotaryGetting Started Combi -XLR ConnectorOperation MIC / Line InputEQ -HIGH Control Level ControlEQ -LOW Control MIC Insert Socket rearconInput Selector Switches Clip IndicatorsPRE-TRIM Pads HI EQ Channel Volume FadersTrim MID EQRecord OUT FX Send & Return / AUXSend -LEVEL Send -SELECTFX SEND/RETURN RE-CONFIGURATION Clip IndicatorFX ON/OFF Switch Return / AUX -LEVELMaster / Booth Output Fader ExciterFader Curve MASTER/CUE Select Headphone MonitorLevel Headphone SocketsMonitor BPM FX Module Bank ModeBeats Indicator Operating CriteriaTAP/CLEAR IsolatorY Controls ON-OFF switches BPM FX MIXConnections Setting UPQuick Start Activating the EffectsTAP/CLEAR Button OperationBPM Range TAP -Tempo EditEffect Start Sync Applying the BPM-FXEffect Controls MIX FaderRotary Encoder Band Isolator SINGLE/MULTI Mode Operation Mode Bank selectSingle Mode Multi Mode Additional speed settings for FILTER/FLANGER/PANNERProgram Edit and Recall Effects FilterFrequency SUB-MENU Delay SpeedRepeats Y PAN SPSWAY Split Y Cutter Depth X mark space ratioSlope Y Flange Resonance is factory set @ 75%Depth Y PRE-SET Voice List Hints & TipsBlock Diagram Connecting Leads Troubleshooting Specifications Warranty Glossary Post after the channel faderEqualising the system to notch out the offending frequencies Riaa